Jandy CL Series Installation And Operation Manual

Manual is about: Cartridge Pool Fil ters

Summary of CL Series

  • Page 1

    H0238700d installation and op er a tion man u al jandy ® car tridge pool fil ters cl series fil ters warning for your safety - this product must be installed and serviced by a pro fes sion al pool/ spa service technician. The procedures in this manual must be followed ex act ly. Im prop er in stal l...

  • Page 3

    Page 3 cartridge pool filters - cl series filter date of installation initial pressure gauge reading (with clean filter) pump model horsepower filter model serial number notes: equipment information record table of contents section 1. Safety information ....................... 4 1.1 important safety...

  • Page 4

    Page 4 section 1. Safety information 1.1 important safety warning 1. Before repositioning valve(s) and before beginning the assembly, disassembly, or adjustment of the clamp, or any other service of the circulating system; (a) turn the pump off and shut off any automatic controls to ensure the syste...

  • Page 5

    Page 5 cartridge pool filters - cl series filter section 2. General information 2.1 introduction this manual contains information for the proper instal- lation and operation of the jandy ® cl series cartridge filters. Procedures in this manual must be followed ex- actly. To obtain additional copies ...

  • Page 6: Section 3.

    Page 6 section 3. Installation instructions 3.1 filter location 1. Select a well-drained area, one that does not fl ood when it rains. Damp, non-ventilated areas should be avoided. 2. Provide solid mounting for the fi lter and pump system. Install system on a concrete slab or solid concrete blocks to ...

  • Page 7

    Page 7 cartridge pool filters - cl series filter 3.3 filter installation 1. This fi lter operates under pressure. When clamped properly and operated without air in the water system, this fi lter will operate in a safe manner. 2. If doubt exists as to the pressure which the system will be subjected to,...

  • Page 8

    Page 8 3.4 clamp installation, cl series 1. Be certain the o-ring is in position in the lower tank half. Press the fi lter lid over the lower half sandwiching the o-ring between the two halves. 2. Holding the ends of the fi lter clamp apart, position the hinged segment of the fi lter clamp over both up...

  • Page 9: Assembly

    Page 9 cartridge pool filters - cl series filter section 4. Start-up and operation note this section applies to both new pool and seasonal start-up. 1. Turn off the pump. Switch off the circuit breaker to the pump motor. 2. Check that the drain plug is in place and tight. 3. Check that the tank clam...

  • Page 10: Section 7. Winterizing

    Page 10 6.2 pressure gauge 10. Using new cartridges or the clean original ones, place the cartridges back into the fi lter tank. Be sure that they are correctly seated on the cartridge support on the bottom of the tank. 11. Inspect the o-ring at the top of the outlet tube for cracks and wear marks. R...

  • Page 11: Section 8. Troubleshooting

    Page 11 cartridge pool filters - cl series filter table 2. Troubleshooting guide fault symptom possible problems solutions water is not clear. Insufficient disinfectant level. Incorrect pool chemistry. Heavy bathing and/or dirt loads. Insufficient running times. Filter is dirty. Hole in filter eleme...

  • Page 12: View

    Page 12 key no. Description part no. 1 handle assembly w/ hardware (set of 2) r0357100 2 handle hardware (set of 4) r0359900 3 gauge/air release assembly r0357200 4 pressure gauge r0569600 5 tank adapter w/o-ring r0552000 6 tank top cl580 r0357300 tank top cl340 & cl460 r0554700 7 top spacer r035770...

  • Page 13: Section 10.

    Page 13 cartridge pool filters - cl series filter section 10. Head loss curves 10.1 jandy ® cl car tridge filter design head loss curves.

  • Page 14

    Page 14 notes.

  • Page 15

    Page 15 cartridge pool filters - cl series filter.

  • Page 16: Limited Warranty

    Limited warranty thank you for purchasing jandy ® pool and spa products. Water pik technologies (manufacturer of jandy products, including laars ® pool and spa heaters, air energy heat pumps, and clormatic electronic chlorine generators) warrants all parts to be free from manufacturing defects in ma...