Jandy Levolor K-1100 Installation Instructions
Levolor is the alternative choice of contractors over mechanical floats;
because it's trouble-free, easy to install and there are no moving parts.
LEVOLOR is a computer-controlled device that detects
a low water condition and automatically replaces the
water to a pre-set level. LEVELOR works well on new and existing
pools and spas. LEVOLOR can be used in any situation
where a consistent liquid level is desired (i.e., pools, spas,
aquariums, ponds, reservoirs, storage tanks,
water cooling towers, etc.).
Electronic Water Leveler
Model K-1100
PWR
Sensor
Filling
Electronic
Water Levelor
The next generation
in automated controls.
SM
M
illenium
System Dynamics
Scottsdale, AZ 85260
800-844-8514
TM
TM
TM
IMPORTANT SAFETY INSTRUCTIONS
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. WARNING: To reduce the risk of injury, do not permit children to
use this product unless they are closely supervised at all times.
3. SAVE THESE INSTRUCTIONS.
4. Sensor wires must be continuous and not spliced.
Call factory with any questions: 1-800- 844-8514
5. Solder all low voltage wire connections when possible and always
use grease-filled wire nuts on low voltage connections.
Patented
High Voltage Compartment
No user service parts
inside
Model No. K-1100
INSTALLATION INSTRUCTIONS
Page 1
Rev E © SDI 2006
LEVOLOR IS A REGISTERED TRADEMARK OF SYSTEM DYNAMICS