Japan CBM CAL TP07 Instruction Manual
CAL TP07
INSTRUCTION MANUAL
5-68-10, Nakano, Nakano-ku,
Tokyo 164-0001, Japan
Phone: (03) 5345-7860, Fax: (03) 5345-7861
SPECIFICATIONS
Reception
Reception frequency
1)GERMANY............ 77.5KHz(DCF77)
2)U.K........................ 60KHz(MSF)
3)U.S.A.................... 60KHz(WWVB)
4)JAPAN.................. 60KHz(JJY)
Automatic reception (maximum two times a day)
Manual reception
Basic functions
Analog part................. Hour/Minute
Digital part
Time......................... Hour/Minute/Sec. (24-hour display or a.m./p.m.)
Calendar................... Month/Date/Day (Auto calender up to 2099)
Alarm ....................... Hour/Min. (24-hour display or a.m./p.m.)
Chime....................... Hourly chime
Stop watch ............... Up to 24 hours
Dual time.................. Hour (24-hour display or a.m./p.m.)
EL Backlight
Battery life .................. About 2 years
Battery........................ CR2016x1
NAMES OF PARTS
CAUTION !
Before using, be sure to set the “COUNTRY AND TIME ZONE”.
For setting of the “COUNTRY AND TIME ZONE”, see
“7.COUNTRY AND TIME ZONE SETTING AND SUMMER TIME
ON/OFF” at right.
TO-Y0062
RADIO WAVE CONTROLLED WATCH
○ About this radio wave controlled watch
This watch receives calibration signal and automatically updates the time
and date.
○ Transmitter
GERMANY
Signal code : DCF77
Location :
Mainflingen Germany (located 25 Km southeast of Frankfurt)
U.K
Signal code : MSF
Location :
Rugby city (located near from London)
U.S.A
Signal code : WWVB
Location :
FortCollins in Colorado (located 100Km north of Denver)
JAPAN
Signal code : JJY
Location :
Mt.Haganeyama (located 45Km southwest of Fukuoka)
The signal usually operates 24 hours of a day, but it may be temporarily
interrupted for maintenance and lightning cuntermeasure.
○ Radio wave reception zone
This watch can receive radio waves within a radius of about 1,000km from
the standard radio wave station. However, the coverage can vary depending
on time, season, weather conditions, local environmental conditions, etc.
MODE=
=ADJUST
=LIGHT
RECEIVE=
Day
Reception mark
Hour
Sec.
Minute
AM mark
PM mark
Summer
mark
Alarm
Chime
Month
Country code
Zone code
Reception level indicator
Date
[TIME MODE]
[CALENDAR MODE]
Which way to point the watch during reception
Flatten the wristband so it doesn't curl
under the antenna.
Radio
wave
station
Antenna
* The indicated reception area is for your reference only. Sometimes you cannot receive radio waves
even within the zone shown in the figure.
○ How to successfully receive radio waves
• It may be difficult to receive radio waves when metal shielding blocks the watch. When
inside a ferroconcrete building etc., try to place the watch near a window that is as close
as possible to facing the radio wave station.
• Try not to move the watch during radio wave reception.
• Good reception can be achieved if you aim the reception antenna (on the upper side of
the watch) toward the radio wave station.
• You can check signal strength by looking at the reception mark that is displayed during
radio wave reception. If you find a place and a direction to aim the watch in advance that
has stable reception, that will help to get a good connection.
* The watch may fail to receive radio waves or may receive them inaccurately near (within
10km from) the standard radio wave station. In this case, change the direction of the
antenna by 45 - 90 degrees or receive radio waves again at a place far (10km or farther)
from the standard wave station.
* Sometimes when the watch indicates strong radio wave reception, it still may not be able
to receive a signal due to surrounding environmental interference such as electrical
noise.
* The maximum time required to receive a complete signal can be up to 13 minutes. It may
change depending on distance from the standard radio wave station, time, season,
weather, etc.
○ Places where it may be difficult to receive radio waves
• Places with extremely high or low temperatures.
• Inside ferroconcrete buildings, underground, inside high-rise buildings, in valleys between
mountains, etc.
• Inside vehicles, trains, and airplanes.
• Places that tend to have electrical noise such as near high voltage cables, electric train
cables, and near airports.
• Near home appliances such as televisions, refrigerators, computers, fax machines,
inverter fluorescent lights, OA machines, and operating cellular phones.
* The watch operates using its built-in quartz accuracy under conditions of poor reception.
When it returns to a reception area and receives radio waves, the watch displays the
correct time. The watch operates using its built-in quartz accuracy between signal
reception cycles.
AUTOMATIC RECEPTION
If you receive radio waves properly, the time and date are adjusted automatically.
• The watch automatically receives radio waves a maximum of two times a day.
• If one of the two reception attempts is successful, automatic reception won't be
attempted again until the next day.
During the daylight saving time period, if the watch receives the radio waves normally, it
automatically displays the SUM. If it receives the radio waves normally after the DST
period, it automatically displays the ordinary time.
• Since the DST is automatically corrected, you do not need to correct it, as long as the
watch receives radio waves. In a district where the DST is not applied, however, you are
required to correct the DST manually.
AUTOMATIC RECEPTION
3:05AM, 4:05AM
Weak radio waves
Strong radio waves
About
About
1,000 km
1,000 km
About
1,000 km
Berlin
Berlin
Berlin
London
London
London
About
About
1,000 km
1,000 km
About
1,000 km
Osaka
Osaka
Nagoya
Nagoya
Sendai
Sendai
Osaka
Nagoya
Sendai
×
N
About
1,000 km
Tokyo
Tokyo
Tokyo
About 1,000 km
Denver
Chicago
Chicago
New York
New York
Los Angeles
Los Angeles
Los Angeles
Chicago
New York
● SELECTION OF DISPLAY
1. MANUAL RECEPTION
Signal reception takes 2~13 minutes.
3. MANUAL ADJUSTMENT TIME
AND CALENDAR
2. CONFIRMING RECEPTION
RESULTS
TIME
CALENDAR
ALARM
CHIME
STOP WATCH
DUAL TIME
SUMMER TIME
TIME
>2Sec.
TIME
Pull
Push
Sec. setting
Sec. set "00"
Min. adjustment
: Increment
Hour adjustment
: Increment
Year adjustment
: Increment
Month adjustment
: Increment
Date adjustment
: Increment
12H/24H Setting
: Increment
Calendar format
: "Month-date"
"Date-month"
Push
to complete adjustment.
The hands are moved forward until
they are set to the time of the
digital section.
CAUTION !
Do not pull
while the hands are
being moved forward.
The latest reception was
successful.
The latest reception was failed.
8. DUAL TIME
• DUAL TIME SETTING
Pull
Push
4. ALARM
• ALARM ON/OFF
5. CHIME
• CHIME ON/OFF
• ALARM SETTING
Alarm off
Alarm on
Chime off
Chime on
Hour setting
: Increment
Min. setting
: Increment
Alarm on
Pull
Push
Timing
Split
Timing
Stop
Reset
6. STOP WATCH
Hour setting
: Increment
COUNTRY CODE
U.K
Germany
Japan
U.S.A
7. COUNTRY AND TIME ZONE SETTING, AND SUMMER
TIME ON/OFF
Select Summer time ON/OFF.
Select a country and a time zone where you will use this watch.
If the country is selected, the radio wave is decided. The relationship between
the countries and radio waves is shown in Table below.
11. BATTERY REPLACEMENT
When the display dims, replace the battery as soon as possible.After battery
replacement, please make sure to short two pattern on module, and reset hands
initial position refering to "10.CHECK AND RESET HANDS INITIAL POSITION".
10. CHECK AND RESET HANDS INITIAL POSITION
It may happen that hands slip and change to incorrect position, because of
hard shock, static electricity and after battery replacement and so on.In this
case, we cannot adjust to correct time, even we receive the wave, because
hands initial position is not correct.
Please check and reset hands initial position as following operation.
Correct hands initial position is "12H00M00S".
* Please don't do following operation, when you don't have any problem.
Pull
Push
Pull
Push back
Push back
Push
and at the same time.
Push
or .
Max.12 Min.
Summer time off/on
Selecut countory
EnG
USA JPn
GER
U.K → USA → Japan → Germany
Select time zone
+0
+1
+2
+3
PS →
MS
→ CS →
ES
(Pacific) (Mountain) (Central) (Eastern)
Push
to complete setting.
The hands are moved forward
according to the setting.
CAUTION !
Do not pull
while the hands
are being moved forward.
TIME ZONE
0
1
0
1
2
3
−
0
1
2
3
CITY
London
Berlin
London
Berlin
TOKYO
PS=PACIFIC STD USA.
MS=MOUNTAIN STD USA.
CS=CENTRAL STD USA.
ES=EASTERN STD USA.
RECEPTION WAVE
MSF(60KHz)
DCF77(77.5KHz)
JJY(60KHz)
WWVB(60KHz)
9. LIGHT
Push
Hands stops at their initial position.
1) In the case of correct position("12H00M00S")
No need to reset hands initial position.
2) In the case of incorrect position( not "12H00M")
Need to reset and adjust hands initial position.
Hands stops incorrect position( not "12H00M").
To move hands to correct position, push
and .
: Fast move
: Push one time then hand moves one step
Hands move back to original time.
CAUTION !
Please don't pull
while hands forwarding.
Hands move back to original time.
CAUTION !
Please don't pull
while hands forwarding.