Japan Kneader MCS201 Owner's Manual - page 2
●Handling
Warning
Caution
Should not be disassembled or modified.
Disassembly or modification could cause malfunction and/or
physical injury.
Children are strictly prohibited from using this
product. Do not use in reach of children.
Please keep fingers, hair, and loose clothing away
from moving parts.
During operation please absolutely do not put your
finger on the movable portion.
Please dry thoroughly after cleaning.
Do not wash in an automatic dishwasher.
Do not cover head or face with the plastic bag.
Do not use on an unstable, powdery, or oily surface.
Falling or tipping of this appliance can cause injury.
Falling or tipping of this appliance can cause injury.
It is also recommended to wipe off the leg-tips of this
appliance before use.
Safety instructions and warnings
-Please read carefully and follow-
●About the Symbols and Marks.
It is presented the possibility of wrong usage. Serious
injury or even the possibility of death may occur.
Indicates possibility of serious injury or even fatality
in case of mistaken usage.
Notes presented here are important safety instructions to prevent any harm
or damage to you or others. Please be sure to follow them.
Never do.
Always follow the instructions
in the Owner’s Manual
Warning
Caution
Meanings of the symbols and marks.
Use this appliance conforming and according to the written
cautions and warnings. Carefully avoid any accidents.
The owner or person in charge of this appliance must not allow
operation by persons who do not understand its usage.
Do not attempt to repair or modify the appliance.
Refer all servicing to authorised repair technicians.
Names and functions of each part
●Main components
●Accessories
・ Operation manual (this manual)
・ Warranty
・ Cutter
Note: The appliance comes with one cutters pre-attached.
(Number, type inscribed on box)
・ Recipe Book*
Lid
Roller cover
(Pasta receptacle)
Handle
Cutter
Clamp (fixed part)
Compatible with of
thicknesses between
10mm and 60mm.
・ If you notice unusual hardness or noise when turning the handle, stop
immediately, remove the roller cover and check for foreign objects.
・ If you find dough is wrapped around the roller, remove the roller cover and
retrieve the dough by reverse rotation.
・ Do not use for anything other than dough.
・ Do not perform reverse rotation more than is necessary.
Operating suggestions and cautions
・ When using the 2mm of cutter (MCC20), please flatten the dough with the dial
set at “3” or below. If the dial is set at “4” the dough may clog the cutter.
・ If dough is jammed in the cutter, the cutter can be soaked for a while in water
without disassembling it. Disassemble after removing the dough under running
water. After the dough is removed, dry thoroughly and use again in completely
dry condition. If used in a moist state, the dough may clog the cutter.
・ There is a risk of mold forming if stored in plastic bags.
・ After use, remove flour and make sure to completely dry after washing
Store in a well-ventilated place.
・ Use bleaching detergent, etc., if difficult to clean.
Storage
*Please refer to pages 21 and 22 of the Recipe Book for
pasta cutting procedure and maintenance.
Remove cutter when
spreading the dough.
Body
You can adjust the
thickness of the dough
into four stages.
Dial