JARC CS1505 User Manual
3
2
Zip Tie
Rubber
Bracket
Wheel Magnet Set
Rubber Bracket Set
Cadence
Magnet
Extension
Rubber
Zip Tie
Device Overview
Install Sensor
Install Cadence Magnet Set
Install Wheel Magnet Set
1
Cadence Sensor
Sensing Point
Speed Sensor
Sensing Point
Battery Cover
Test Key
Cadence Magnet Set
for crankarm
Top View
IMPORTANT NOTE
Align Cadence Magnet with Cadence Sensor
Sensing Point as shown. Proper distance between
sensor and magnet should be less than 10 mm
Install Cadence Magnet on left crankarm near pedal
as shown. Do not tighten zip ties completely to
allow magnet placement. Use Extension Rubber for
proper distance adjustment
Top View
IMPORTANT NOTE
Align Wheel Magnet with Speed Sensor Sensing
Point as shown. Proper distance between sensor
and magnet should be less than 10 mm. Use screw
driver for proper distance adjustment.
Pre-fit Sensor and Rubber Bracket on left rear
chainstay (non-drive side) and trim excessive
rubber from bracket. Ensure the battery cover is
facing up. Install zip ties loosely to allow sensor
placement.
Unscrew the wheel magnet
to install on spoke.
For Round Spokes
For Bladed Spokes
Cadence
Magnet
Cadence Sensor
Sensing Point
CS1505
Speed & Cadence Sensor
User’s Guide
INSTALLATION