Jari Monarch Owner's Manual

Summary of Monarch

  • Page 1

    Caution never attempt to work on your jari mower without first removing the spark plug or wire from spark plug. Never wear loose clothing near the unit when the engine is operating. Before starting the engine, clear the area of adults, children and pets. A sudden gust of wind and/or an unexpected mo...

  • Page 4

    Parts and accessories not illustrated part # 204600 207300 104700 211500 zerk, straight, (drive in), used in cap screw #73 on wheel and power unit shaft #35. Zerk 67 ½ (-threaded) used in dual pulley assy. #59. Eccentric pin, used in drive head, shown immediately behind #103. Throttle cable, 48” con...

  • Page 5

    By pulling this lever to the right slightly or start position the belts are loosened enabling the engine to be started without any operating load. Put lever #78 in down position. 3. Close choke completely and pull starter rope once. Open choke slightly and pull rope again. When engine starts, gradua...

  • Page 6

    2. It is not necessary to use the full throttle setting provided on your jari. Generally, ¼ to ¾ speeds is adequate to cut whatever is at hand. Start with ¼ speed and if engine lugs, gradually, increase speed to point where engine does not lug. Over the years as the engine wears, it will take more t...

  • Page 7

    Jari mowers, llc 54456 gadwall rd. Mankato, mn 56001 phone: 507-625-3340 fax: 507-388-3973 email: info@jarimowers.Com www.Jarimowers.Com.