Jarv JRV-SBD1000 User Manual - Press The Mode Button.

6) Stride Length Setting: In the state of time display 

(if using the Imperial system), press the MODE button 

twice, then press the SET button for 2 seconds to enter 

the stride length interface, press the MODE button to 

adjust stride length, the range is from 10 to 80 inches, 

the stride length will increase by 2 inches increments 

when pressing the MODE button, default range starts at 

24 inches. If using the Metric system, the range is 30 to 

200 cm, default range starts at 60cm, and the stride 

length will increase by 5cm increments when pressing the 

MODE button. Once stride length has been adjusted 

correctly, Press the SET button to confirm and exit.

7) Weight Setting: In the state of time display (if using 

the Imperial system), press the MODE button 3 times, 

then press the SET button for 2 seconds to enter the 

weight setting interface, press the MODE button to 

adjust weight, the range is 70 to 250lbs, the weight will 

increase by 5lbs increments when pressing the MODE 

button, default range starts at 130lbs. If using the Metric 

system, the range is 30 to 120kg, default range starts at 

60kgs, and the weight will increase by 2kg increments 

when pressing the MODE button. Once weight has been 

adjusted correctly, Press the SET button to confirm and 

exit.

8) Displaying Information: In the state of time display, 

press the MODE button continuously to display the time , 

steps taken, distance traveled, calories burned and SP 

timer. Information shown on the screen will vary as you 

press the MODE button.

9) Step/Distance/Calorie Tracking Reset: In the 

state of time display, press the MODE button once, enter 

into the step tracking interface, press the SET button , 

and activity tracker will be reset to 0. 

10