Jarvis 425-16 Operation Instructions Manual - page 3
Model 425--16
page 3 of 16
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457-4926
UNITED STATES OF AMERICA E--MAIL.
jarvis.products.corp@snet.net
TEL. 860-347-7271 FAX. 860-347-6978 WWW.
jarvisproducts.com
JARVIS
6225030::.
®
safety messages to operators,
maintenance and cleanup personnel
1. Disconnect all hydraulic and air hoses and shut the power off in accordance with OSHA’s lockout/
tagout procedures (29 CFR 1910.147) before sharpening blades.
2. Disconnect all hydraulic and air hoses and shut the power off in accordance with OSHA’s lockout/
tagout procedures (29 CFR 1910.147) before performing any repair or maintenance.
3. Disconnect all hydraulic and air hoses and shut the power off - or have all hydraulic and air hoses
disconnected and the power shut off - in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before performing any cleanup.
4. Disconnect all hydraulic and air hoses and shut the power off when the tool is not being used.
5. Clean up any spilled or leaked hydraulic fluid.
6. Never put fingers, hands or other parts of the body on the cutting edge, in the cutting path or in the path
of the moving links.
7. Test the tool prior to use or daily. Depress one trigger, then pause one second and depress the other
trigger and the blades should not close. Repeat this procedure reversing the triggers. Depress both
triggers simultaneously and the blades should close. With the blades closed, release one trigger and
the blades should open. Continue holding the depressed trigger and then depress the other trigger.
The blades should not close. Repeat this procedure holding the other trigger. If the tool malfunctions,
remove it from service and report or repair it immediately.
8. Never depress the triggers unless you want to use or test the tool.
9. Never make modifications or alterations to the tool. Report or replace any missing or illegible labels.
SAFETY MESSAGES TO OPERATORS, MAINTENANCE AND CLEANUP
PERSONNEL
REMOVE ANY MALFUNCTIONING TOOL FROM SERVICE
REPORT ANY PROBLEMS TO YOUR SUPERVISOR
Keep hands clear.