Jarvis SER-02 Instruction Manual - page 3
notice to operators, maintenance
and cleanup personnel
Model SER--02
page 3 of 8
®
JARVIS
6205014
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457--4926
UNITED STATES OF AMERICA E--MAIL.
jarvis.products.corp@snet.net
TEL. 860--347--7271 FAX. 860--347--6978 WWW. j
arvisproducts.com
NOTICE TO OPERATORS, MAINTENANCE AND CLEANUP PERSONNEL
REMOVE ANY MALFUNCTIONING TOOL FROM SERVICE
REPORT ANY PROBLEMS TO YOUR SUPERVISOR
1. Always wear eye protection in accordance with OSHA’s eye and face protection requirements (29 CFR
1910.133), and when needed, a dust mask.
2. Disconnect the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before changing the blade.
3. Disconnect the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before performing any repair or maintenance.
4. Disconnect the power supply -- or have the power supply disconnected - in accordance with OSHA’s
lockout/tagout procedures (29 CFR 1910.147) before performing any cleanup.
5. Disconnect the power supply when the tool is not in use.
6. Never put fingers, hands or other parts of the body on the cutting edge of the blade or in the cutting path.
7. Test the tool prior to use or daily. Depress the trigger and the tool should start. Release the trigger
and the tool should stop. If the tool malfunctions, remove it from service and report or repair it immedi-
ately.
8. Never depress the trigger unless you are going to use or test the tool.
9. Never make any alterations to the tool. Report or replace any missing or illegible labels.
10. Always use both hands when starting and operating the tool to avoid the risk of possible “kick back”
or “recoil”. Continue holding the tool firmly with both hands until the saw blade comes to a complete
stop.
Keep hands clear.