1. DL manuals
  2. Jarvis
  3. Saw
  4. Wellsaw 400
  5. Operator's Manual

Jarvis Wellsaw 400 Operator's Manual

Other manuals for Wellsaw 400: Owner's Manual, Owner's Manual

Summary of Wellsaw 400

  • Page 1

    Model 400 wellsaw air powered reciprocating saw table of contents page . . . . . . . . . . . . . . . . . . . . . . . . . Equipment selection ordering no. . . . . . . . . . . . . . Model 400 115v wood cutting, 8tpi, 8 in blade 4005200 . . . Wood cutting, 12tpi, 8 in blade 4005202 . . Wood cutting, 8t...

  • Page 2

    Pg 2 of 8 model 400 jarvis 6205005:::: ® 1. Ensure that employees wear eye protection in accordance with osha’s eye and face protection re- quirements (29 cfr 1910.133) at all times. 2. Follow our installation and maintenance instructions for proper installation and care of the tool. 3. Enclosed are...

  • Page 3

    Pg 3 of 8 model 400 jarvis 6205005:::: ® 1. Disconnect the power supply in accordance with osha’s lockout/tagout procedures (29 cfr 1910.147) before changing the blade. 2. Disconnect the power supply in accordance with osha’s lockout/tagout procedures (29 cfr 1910.147) before performing any repair o...

  • Page 4

    Pg 4 of 8 model 400 jarvis 6205005:::: ® parts diagram cutlerymania.Com is an authorized online parts distributor supplying original jarvis products. . E-mail: info@cutlerymania.Com fax: 973-751-7701 telf: 973-751-7775 www.Cutlerymania.Com.

  • Page 5

    Pg 5 of 8 model 400 jarvis 6205005:::: ® it. Part name qty jarvis part no. Old part no. Replacement kits blades, blade supports and accessories it. Part name qty 1 1063112 501022--005 brush cap 2 2 1063111 501022--004 brush and spring 2 3 1063110 501022--003 brush holder 2 4 1015006 501174 deflector...

  • Page 6

    Pg 6 of 8 model 400 jarvis 6205005:::: ® specifications motor power 1 hp 745 w operating volt/amp 230v/3.5a, 1 phase, 50/60 hz 115v/7a, 1 phase, 50/60 hz stroke 1.13 in 29 mm blade speed 8000 strokes / min control handle single trigger electric blade length 8 in 203 mm 16 in 406 mm overall length (1...

  • Page 7

    Pg 7 of 8 model 400 jarvis 6205005:::: ® 6. The saw should be pushed firmly into the mate- rial while cutting. 7. Do not allow the saw blade or the blade support to leave the work piece while cutting. 8. Never allow the saw blade to float into material while cutting. 9. Never permit any part of the ...

  • Page 8

    Pg 8 of 8 model 400 jarvis 6205005:::: ® 5. Remove the cap nuts and the blade support cov- er. The inserts should now be properly set into the saw housing. 6. Assemble blade support (item 59) over the in- serts on the saw housing. Place the blade sup- port cover on the saw housing and fasten with th...