1. DL manuals
  2. Jas Audio
  3. Amplifier
  4. JAS Bravo 1.1 LE
  5. Owner's manual

Jas Audio JAS Bravo 1.1 LE Owner's manual

Manual is about: High End Vacuum Tube Pre-Amplifier Limited Edition

Summary of JAS Bravo 1.1 LE

  • Page 1

    Owner’s manual jas bravo 1.1 le high end vacuum tube pre-amplifier limited edition note: before installing your new bravo 1.1 le audio p r e - amplifier, please read this manual carefully. I t will inform you of the product specifications and also proper installation and operation procedures. For ad...

  • Page 2

    Jas audio high end vacuum tube pre-amplifier bravo 1.1 le welcome to jas audio family! This jas bravo 1.1 le vacuum tube pre-amplifier is designed and manufactured to the highest quality standards in design and craftsmanship. S e p a r a t e m a t c h i n g c a b i n e t s o f p i a n o f i n i s h ...

  • Page 3

    Bravo 1.1 le owner’s manual introduction thank you for purchasing the jas audio bravo 1.1 le vacuum tube pre-amplifier. Exquisiteness of this rep-amplifier is accomplished by utilizing two boxes made of mdf for accommodating the circuit and the power supply separately. Having installed with two sets...

  • Page 4

    Supply are housed separately in two wooden boxes. They should be linked together by a power connecting cable before putting into operating condition. Please ensure that the connecting cable is properly and securely connected between the main circuit box and the power supply. A remote control is supp...

  • Page 5

    Page 5 of 9 http://www.Jas-audio.Com electrical hazard! Misuse or failure to follow instructions properly may result in personal injury or death! Caution: no risk of personal injury; however, misuse or failure to follow instructions may result in damage to equipment. Note: no risk of personal injury...

  • Page 6

    Page 6 of 9 http://www.Jas-audio.Com signal in signal out power in power requirements: the bravo 1.1 le is designed to operate from the ac mains (house current) and is pre-set in the factory according to local supply of the import region. A standard iec ac power socket with a built-in fuse is provid...

  • Page 7

    Page 7 of 9 http://www.Jas-audio.Com tubes light up after pressing the power switch at on position while the gain control knob on the main box is at 0db or 3db. Power on operation your new pre-amplifier is ready for operation when the tubes are properly installed, and the input interconnect cables f...

  • Page 8

    The piano lacquer finish chassis of both the main box and the power supply may only be cleaned with high quality soft cloth similar to that for lens cleaning. Before attempting to clean the surface, make sure that there isn’t any dust or particles left on the surface. Blow before wiping is always re...

  • Page 9

    Was purchased. 2. If the equipment is being used outside the country of purchase, you should contact jas audio national distributor in the country of residence who will advise where the equipment can be serviced. To validate your warranty, you will need the original sales invoice or other proof of o...