Jasco 45233 User Manual - page 3
INSTALLING THE CAMERA (TRANSMITTER) ///
1.Unpack the Camera.
2.Place the Camera in an optimal position
3.To use the 9V camera power adapter, connect power jack to the input on the
base of the Camera. Make sure the Camera is positioned no more than 5 1/2 feet
from an AC power outlet
4.Desktop mounting
Just place the camera to where you want to, and make sure the camera is
within the RF range. As shown below:
5.Wall mounting
6.The Camera (Transmitter) installation is now complete.
NIGHTVISION ///
The camera includes IR LEDs, which allows viewing up to 5 feet in the dark when
used with the adapter. To turn on the IR LEDs, there is a small photoconductive
resistor on the front
of the Camera,
which enable the camera automatically turn on
the IR LEDs on low light conditions.
MULTI-CAMERA OPERATION ///
The JASCO™ Wireless Camera System is designed to work with up to (2)
Cameras. Additional Cameras are sold separately. IMPORTANT: When using
more than one Camera, make sure each Camera is assigned to a specific
channel by adjusting the corresponding slide switch left or right. The slide switch
is located at the underside of the camera housing.