Jay Kordich Power Gring Pro Instruction Manual - page 6
IMPORTANT SAFEGUARDS: PLEASE READ CAREFULLY
1. Use an independent 120V power supply as shown on the specification
label on the motor unit.
2. Do not operate the Power Grind Pro if the power cord is damaged or wet.
3. Do not operate the Power Grind Pro if the housing, cover, strainer basket
or any other part is damaged.
4. Make sure the unit is unplugged before cleaning, assembling or
disassembling its parts.
5. Damaged parts should be replaced by the supplier or its service agent
immediately. Otherwise, they should be repaired by a qualified
technician.
6. Check all parts before operating. Make sure the strainer basket is
securely locked into position before turning on.
7. Place the cover in position and slide the handle bar up and into the
locking position. There are grooves on the cover where the handle bar
rests in its correct position. This will release the safety switch.
Important: If the handle bar is not securely locked in its correct position,
the juicer will NOT turn on, as a safety precaution.
8. Ensure the bottom thimble of the pulp collector touches the limit hole.
Keep this area dry!
9. Close adult supervision is essential when children are present.
10. During operation, do not put hands or any other object other than the
plunger into the feeding chute to push contents in.
11. Improper operation or continuous juicing for longer than 30 minutes will
trigger the temperature control to automatically cut off power. Please
allow the unit to cool down for at least 30 minutes before resuming
operation.
12. In the event of abnormal vibration during operation, unplug the unit
immediately. Remove any leftover pulp and thoroughly clean the
strainer basket and lid before reassembling.
13. All grains, beans and nuts should be soaked for at least 6-12 hours
before grinding. This will ensure a pure and aromatic “sauce”.
14. Always flush through softer fruits or vegetables (i.e. spinach,
parsley, kale) with harder vegetables (i.e. carrots, celery) to prevent
blockage of the strainer basket from excess fibers.
15. The safety lock bar should be unlocked/pulled down only after the
power is switched off and the juicer has stopped completely and the
machine is unplugged.
16. Clean all parts for pulp. Never immerse the base motor unit in water
or any other liquid. Simply wipe with soft damp cloth and dry before
reassembling.
17. Store away from the reach of children.
18. If the motor does not work when the power is switched on, please
unplug the unit and make sure it is properly assembled. Remove any
leftover pulp on parts or motor unit. Clean the parts and reassemble
according to Product Assembly directions.
8
9