Jay-tech FS170 User Manual - 4. Loading Slides

4. Loading Slides

Hold up the slide toward the light. Face the

trademark side of the slide away from you. Look

through the slide and it should appear normally

(not a mirror image).

Now turn the slide so the image is upside down

while looking at the same side.

Open the slide holder at the marked spot on

the top.

With the slide holder laid open place the slide

into recessed area in the holder- the slide

should fit perfectly.

Note: Handle slides with care. Any dust scratches or fingerprints will show up

on your saved images. If possible use cotton gloves when handling slides. It

is recommended to use compressed air to remove any dust on the slides.

This is not included with the film scanner but can be purchased from an office

supply or electronics retailer.

Close the slide holder and press the edges so

that it locks in place.

Hold it in the position as shown in the film

scanner.

Insert the Slide Holder into the slot on the

right side of the film scanner as shown.