Lcd portable metal detector with in built speaker user manual 1.
Assembly 1. Relax the end of the bend-shape tube sleeve clockwise, and insert the aluminum tube which connects the search coil into the tube sleeve, adjusting the length so that you can stand comfortably and straighten your arms,when the search coil is from the ground about 1/2 inches,then lock the ...
Control box.(fig.4) fig. 4 4. The arm support has two positions,t he initial position is that the arm support is in longer location, if your arms are shorter then you can adjust the arm support position. Please release the left and right screw under the arm support when regulation to loosen the left...
Fig. 6 2. Insert the 6 x aa batteries into the compartment as indicated by the polarity symbols marked inside the compartment. (fig 6) fig. 7 3. Close the battery cover. Please notice the “up” direction indication on the battery cover. 6 x alkaline batteries can operate up to 40 hours battery life ....
On the top of lcd screen is the target id，namely target identification cursor. On the bottom is the depth-sens, namely the depth and sensitivity shared cursor. The central left is the low-voltage indication cursor. when searching,the target identification cursor divide the metal targets into three...
Target categories indication sound target id indication iron nail low tone iron is illumined and flickered about 5 seconds nickel,coins medium tone mid range is illumined and flickered about 5 seconds 25 cents high tone silver is illumined and flickered about 5 seconds 3， four kinds of discriminatio...
Fig. 9 please take off any watches, rings or other metal objects on your hand or arm. Keep the detector away from any walls, floors and other metal objects. be sure to keep the detector away from the light, tv, computer or mobile phones, which can cause electro-magnetic interference. 3． turn on ...
When turning on the unit, the detector is at the all metal state,sweep the metal sample above the center of the search coil (5cm) operate indicatio n tone lcd target id lcd depth- sens chart note turn on turn on indicatio n nothing displayed sens-3 is illuminated sweep iron nail a low tone the iron ...
Sweep iron nail silent iron flickers once sens-3 flicker sonce nickel, coins a medium tone mid range is illuminated and flicker depth-2 is illuminated and flickers silver a high tone silver is illuminated and flicker depth-2 is illuminated and flickers 6. Eliminate the medium conductivity metals ope...
7. Eliminate the iron and the medium conductivity metals at the same time operate indicatio n tone lcd target id lcd depth- sens chart note press mode button it responds with low, medium tone alternate ly,and repeats three times iron、 mid range is illuminated at the same time sens-3 is illuminated n...
Note: if you detect with your more than one metal detector, please keep at least 5m apart. 3.Choose the discrimination modes press the mode button, you can choose from the four discrimination modes,if you are not interested in iron targets, you can choose to reject the iron,if the pull-tabs off cans...
Quickly,to help you get the more steady signal. 5.Pinpoint the target when there is a clear signal to show you the location of the buried target objects,you can “x” the target at different angles to zero on the exact spot on the ground where the “beep” occurs. You can do a "x" scan in this district,...
