Digital smart 6/12/24v, 15a dc auto-detection battery charger suitable for regular (wet/ flooded/ sealed/ maintenance free) lead acid, gel / sla and deep cycle batteries between 20-200ah.
Please carefully read and follow the following safety and operating instructions. Gases when the battery is being charged you may notice bubbling in the fluid caused by the release of gas. As the gas is flammable no naked flames should be used around the battery, and the area should be kept well ven...
Features automatic and intelligent 5-stage charging curve mb-3623 is controlled by a 12-bit ad microprocessor with 4/5-stage charging characteristic for charging batteries lawnmower, automobiles, motorcycles, snow mobiles, tractors, personal watercraft, boats, minibus, coach, truck, etc. A microproc...
6v battery(voltage) 12v battery(voltage) charging characteristic at 6v: charging characteristic at 12v: charging characteristic at 24v: 20～28.8v gel cell/sla:28.0v regular:28.4v deep cycle:28.8v 27.22v(at:25℃) auto detect 16～20v 2a 2a 2/7a 10 minute(max) 9 hour(max) 36 hour(max) 24v battery(voltage)...
Led display the unit is built with led display for showing charger status: reverse – red led – alligator clamps are connected in reverse polarity. fault - red led – battery fault. charging – amber led – the charger is charging to the battery. full - green led – the battery is fully charged a...
Short-circuit protection should you accidentally touch the alligator clamp together whilst the mains power is on, the unit will not perform charging. Unplug from ac power mains, disconnect and start the process again being careful not to cross the alligator clamps together. Temperature control fan t...
4. Control panel the control panel has several buttons and indicators. Charge rate button sets the charge rate to one of the following: 2a dc slow – applicable on 6v/12v/24v battery, at a 2amp dc slow rate charging. The 2a rate is not intended to be used as a trickle charger for larger batteries. 7a...
Led indicators on the front panel there are also 4 led indicators for the following function: reverse – reverse polarity. The alligator clamps have been connected at the wrong pole on the battery. When this occurs, simply disconnect and reconnect the alligator clamps at the correct pole, restart the...
If you select non-applicable charging rate, after auto-detection process, charging will start at factory pre-set charging rate at 2amp and 2a illuminates on led main display. Insert the ac plug into the mains supply (220-240 volts ac only). When beep sound is heard and “2a” lights up on led main dis...
Where appropriate, if the battery has been removed for charging, replace it and reconnect the cables. Protection a) reverse polarity if the alligator clamps are connected improperly to the battery terminals, the reverse polarity led will indicate the reversed polarity; warning buzzer will also sound...
Care sometimes the battery may appear flat, but this could simply be dirty or loose connections on your battery terminals. It is important to maintain the leads on a regular basis. Do this by removing the leads from the battery, clean the inside of each connector and terminal posts on the battery, s...
For 12v normal lead acid, sealed, leisure, gel or deep cycle batteries input: 220v – 240v ~ 50hz, 2.5a (max.) output: 2a dc for 6/12/24v battery; 7a dc for 12/24v battery; 15a dc for 12v battery waste electrical products should not be disposed of with household waste. Please recycle where facilities...
