JB LEDA7 Operating Instructions Manual - 4. Control Panel
4. Control panel
To adjust the personal setting of the JBLED A7 zoom use keys located on the control
panel. Functions see menu on the following page.
The JBLED A7 can be addressed in the main menu. For addressing in a case, the reset
can abort by pressing the right base button during powering the fixture. The main menu
also informed about the DMX-mode. If wireless DMX is used, the field intensity from the
sender will be displayed.
Press "ENTER" to enter a menu, select a function or apply a selection.
Press keys "DOWN" and "UP" to scroll within a menu or set values.
To escape a function press key "ESC".
A few functions can be entered or recalled by means of a combination of two key.
The main menu can be locked to avoid an accidental change of the configuration.
To lock
The display is not illuminated during reset.
Slow flashing of the display illumination means no DMX signal is connected.
Fast flashing of the display illumination showing
means a failure was
reported and stored in the ERROR LIST (To clear - see menu navigation on page 24).
Fast flashing of the display illumination showing an error message means an current
failure is reported, e. g.
- please contact your dealer or our service
department.
If the JBLED A7 receives a DMX-signal the display illumination dims out after 30
seconds in order not to irritated during standard operation.
Special functions are assigned to the display lighting:
JB-LIGHTING
*PAN TIMEOUT
For example
in the
area and
in the
. To enter these functions press “ENTER” and keep it down and
press “ESC” in addtion.
To leave the menu press the combination in the revers order. Press "ESC" (keep it down)
and press "ENTER" in addition.
FINE ADJUST
SERVICE
STANDALONE
MODIFY RUN
REMOTE
,
and
press “ENTER” and keep it down and press “ESC” in addition. To unlock press
"ESC" (keep it down) and press "ENTER" in addition.
Rotating the display
The JBLED A7 is equiped with a backlit graphic display, which can be rotated through 180
deg if the unit is installed upside down.
The orientation of the display relys to the keys which are being pressed. There are two
sets of keys located above and below the display and it orientates itself to the direction of
keys of which one key has been pressed.
23
JBLED A7
ESC
ENTER
DOWN
UP
JB - LIGHTING
JBLED A7
ESC
ENTER
DOWN
UP
001
JB - LIGHTING
001
S8
S8