JB-Lighting Varyscan P3 Operating Instructions Manual - 5. Service

5. Service

5.1 Gobo change

The gobos are fixed by means of a spring. To change gobo remove spring and

gobo and insert the new gobo. Readjust the spring to fix the gobo. Make sure

that the blacked side of the metal gobo is positioned opposide the lamp

(in direction of the objective). If you insert glass gobos make sure that the coated

side is positionend in opposide direction to the lamp.

If you want to order custom made gobos, have a look at the technical diagram.

Image diameter:  33 mm

Diameter:  37,5 mm (+0/-0,2 mm)

Position head in horizontal position. Hinge no. 1 must be on the

upper side of the head. Turn screws no. 2 1/2 turn left and remove

plastic lid.

Loosen knurled head screw no. 3 and remove the gobo module.

Standard assembly

33 mm

37,5 mm

1

2

3

WARNING: Disconnect fixture from mains, and allow

hot lamp to cool down for at least 30 minutes!

!

31