JB-Lighting Varyscan7 Operating Instructions Manual - 2. Installation

2.1 Installing or changing the lamp

WARNING: Disconnect fixture from mains, and allow

hot lamp to cool down for at least 30 minutes!

2. Installation

Position head in horizontal position. Hinge no. 1 must be on the

upper side of the head. Turn screws no. 5 1/2 turn left and remove

plastic lid.

.

Loosen knurled head screw no. 3 and open the lampcover

Light source:  OSRAM HMI 1200W/S

Install a 3-prong gounding type plug that fits your supply

Connected load: voltage 230V, frequency 50Hz, Power 1700 VA

WARNING: To ensure propper installation of the plug consult a qualified

technician!

2.2  Powering the fixture

brown             live

“L”

blue                neutral

“N”

yellow/green  gound

Nipple

Insert the lamp into the lamp holder. The nipple of the lamp

must face the top lid of the head. (See sketch).

If changing the lamp, remove old lamp from

lamp socket. Hold the new lamp only by its

ceramic base. Never touch the glass bulb.

21

1

3

2