Jbc AL250-B Manual - page 5
Other manuals for AL250-B:
Manual
of
8
5
1. Loosen the cartridge screw to release it.
Place the new cartridge in the Auto-feed iron.
Alignment
Guide tube
Ref . 0002401 - Ø 0,9 - 1,1 mm
Changing cartridge
For a safe cartridge change, unplug the tool or turn the station off before following these guidelines:
2. Align the tip of the cartridge with the solder Guide tube.
Important: It is essential to insert the cartridge till the end for a good connection. Use the mark as
reference. Tighten the cartridge screw.
3. You must leave a gap of 8-10 mm between the tip and the end of the Guide tube.
4. Loosen the guide screw. Adjust the Guide tube and tighten the screw.
1
3
4
2
www.jbctools.com
8-10 mm