1. DL manuals
  2. JBJ
  3. Water Filtration Systems
  4. Submariner UVF-5W
  5. Owner's Manual

JBJ Submariner UVF-5W Owner's Manual

Manual is about: JBJ 5 Watt & 7 Watt Models Submariner UV Sterilizer/Clarifier

Summary of Submariner UVF-5W

  • Page 1

    Transworld aquatic enterprises inc . Owner’s manual 5 watt & 7 watt models.

  • Page 2

    2 table of contents important safety instructions 3—5 parts 6 introduction 7 installation 8-9 operation 10 maintenance procedures 11-14 maintenance log 15.

  • Page 3

    3 a. Carefully examine the uv appliance prior to installation. Since the lamp and quartz sleeve are fragile, they may have been damaged during transport. B. Do not operate the uv appliance if it has any breakage or cracks within the lamp or quartz sleeve. C. Do not operate the uv appliance if the uv...

  • Page 4

    4 f. To avoid the possibility of the ap- pliance plug or receptacle getting wet, position aquarium stand and tank to one side of a wall mounted receptacle to prevent water from dripping onto the receptacle or plug. A “drip loop”, shown in the figure at the right should be arranged by the user for ea...

  • Page 5: Save These Instructions

    5 it is important to keep this appliance clean. Always unplug the appliance before performing maintenance or cleaning of the pre-filter sponge, pump, and quartz sleeve.. . Make sure hands are completely dry before re-plugging into an electrical outlet. In order to assure proper electrical connection...

  • Page 6

    6 description part # pump motor + swivel spout uvf-1 adjustable flow valve uvf-2 magnetic impeller uvf-3 ceramic shaft uvf-4 impeller housing cap uvf-5 suction cup mounting bracket uvf-6 remote ballast uvf-7 on/off switch uvf-8 power cord uvf-9 uv lamp connection (pre-wired) uvf-10 quartz sleeve –ca...

  • Page 7

    7 thank you for purchasing the proactive solution to eradicating harmful mi- cro-organisms and unattractive green free-floating algae in fresh & saltwater aquariums. This revolutionary uv sterilizer/clarifier is completely submersible, which can be placed either in the main body of the aquarium or p...

  • Page 8

    8 pump powercord connection connect the powercord leading from the pump into the remote ballast. This connection will allow you to utilize the integrated power outlet for a clutter-free set up. The pump powercord may also be plugged independ- ently into a 115v outlet. . Caution: inspect uv lamp & qu...

  • Page 9

    9 choosing a location adjusting flow rate + swivel spout nozzle the ability to adjust flow rates puts you in total control of what you intend to eradicate. Slower flow rates increase dwell (contact time) period with the uv for more resistant parasites while faster flow rates are needed to rid undesi...

  • Page 10

    10 operation mode operation –principle caution: pump should always be securely “snapped” into the main body of the uv for a secure fit. The submariner uv-c sterilizer/clarifier is preassembled for quick operation. Once installed and positioned securely, you will gain instant germicidal bene- fits ag...

  • Page 11

    11 maintenance made simple replacing the pre-filter sponge –monthly regular maintenance is the key to consistent disease control. Please perform routine maintenance on your uv for peak performance: • replacement of pre-filter sponge / monthly • cleaning of the quartz sleeve / monthly • cleaning of t...

  • Page 12

    12 replacing the uv-c lamp—yearly the uv-c lamp has an average life span of 8000 hours of operation. Al- though the lamp may illuminate, it will not perform effectively for disease control. Lamp should be replaced before it expires. Unsnap the pump from the uv (page 11) and remove the quartz sleeve....

  • Page 13

    13 replacing the uv-c lamp step 4: align quartz sleeve cap within the notched grooves of the lamp removal tool. Step 5: firmly grasp. Lamp removal tool and quartz sleeve and pull apart. Step 6: firmly grasp the base of the uv- c lamp and pull apart from quartz cap. Caution: it is important that the ...

  • Page 14

    14 recommended maintenance customer service information for additional information or technical support, please call us at (310) 672-4099 , m-f from 9am-5pm (pacific stan- dard time). Model uvf-5w uvf-7w uv lamp pl- 5 watt pl-7 watt volts/hz ac110v/60hz ac110v/60hz pump flow: min/max 74-132 gph 74-1...

  • Page 15

    15.

  • Page 16

    16 visit us at www.Jbjlighting.Com transworld aquatic enterprises, inc 3730 w. Century blvd #3 inglewood, ca 90303 phone: (310) 672-4099.