JBL BPx1100.1 Owner's Manual

Other manuals for BPx1100.1: Owner's Manual, Service Manual, Service manual
Manual is about: 2 CHANNEL POWER AMPLIFIER

Summary of BPx1100.1

  • Page 1

    Car audio power amplifier owner’s manual thank you for purchasing a jbl power series ® amplifier. In order that we may better serve you should you require warranty service for your new amplifier, please retain your original purchase receipt and return the enclosed warranty registration card..

  • Page 2

    Installation warning: playing loud music in an automobile can hinder your ability to hear traffic and permanently damage your hearing. We recommend listening at low or moderate levels while driving your car. Jbl accepts no liability for hearing loss, bodily injury or property damage resulting from t...

  • Page 3

    Applications – bpx models to the right are several application diagrams to help plan your subwoofer system installation. Figures 1 through 3 show how to configure the jbl power series subwoofer amplifiers (models bpx500.1, bpx1100.1 and bpx2200.1) for 2-channel, bridged-mono and parallel-mono operat...

  • Page 4

    4 applications – px600.2 the jbl px600.2 amplifier can be set up for stereo or bridged-mono operation, as shown in figures 4 and 5 . Note: for simplicity, figures 4 and 5 do not show power, remote and input connections. Px600.2 (rear panel) power fuses gnd rem batt speaker outputs bridged stereo px6...

  • Page 5

    5 applications – px300.4 the jbl px300.4 amplifier can be set up for stereo or tri-mode operation, as shown in figures 6 and 7 . Note: for simplicity, figures 6 and 7 do not show power, remote and input connections. Px300.4 (rear panel) power fuses gnd rem batt px300.4 speaker outputs speaker output...

  • Page 6

    6 installation and setup setting the output mode setting an output mode depends on your choice of system configuration and the nominal impedace of your speaker system. Jbl power series bpx amplifiers provide rated power into any impedance between 1 and 4 ohms. The bpx500.1, bpx1100.1 and bpx2200.1 a...

  • Page 7

    7 installation and setup for sealed enclosures, use dbo to enhance the middle of the bass region. Set the hp freq control to 35hz to 40hz and adjust the boost control to taste. This will make the bass sound bigger and fuller. Alternatively, for tighter-sounding bass, set the hp freq control between ...

  • Page 8: Www.Jbl.Com

    Www.Jbl.Com specifications declaration of conformity we, harman consumer international 2, route de tours 72500 chateau du loir france declare in own responsibility that the products described in this owner’s manual are in compliance with technical standards: en 55013:2001 en 55020:2002 emmanuel mill...