JBL DECADE Owner's Manual

Summary of DECADE

  • Page 1

    D e c a d e ™ a m p l i f i e r s d a 4 0 0 2 , d a 6 5 0 2 , d a 3 5 0 4 , d a 1 0 0 2 g e n u i n e j b l da om 7/14/98 11:38 am page 1.

  • Page 2

    2 amplifier features • 4-, 3- or 2-channel operation (da3504) 2- or 1-channel operation (da4002, da6502, da1002) • simultaneous stereo and mono operation • built-in 12db/oct electronic crossover • oversized floating rail mosfet power supply • floating ground factory-head-unit speaker-level input • v...

  • Page 3

    + – + – left right + – bridged speaker output power fuse 20 amp rem gnd( – ) batt( + ) 20 3 4 5 da4002/da6502 3 controls and connectors 1. Pre-amp line level input connector – connects to line-level output from the source unit. 2. Floating ground factory-head-unit interface speaker input – connects ...

  • Page 4

    4 wiring the speaker output connections 1. Connect the speakers, observing proper polarity, to the speaker output barrier strip on the amplifier using at least 16g high-quality speaker wire. (note: the total impedance of the speakers connected to the outputs when the amp is driven in stereo must be ...

  • Page 5

    5 observe the following color-codes: left+: white left–: white with black stripe right+: gray right–: gray with black stripe 4. If you are connecting your decade series amplifier to a source unit with output voltage higher than 4v, connect the output signal wires of the source unit to the floating g...

  • Page 6

    Applications for your convenience, we’ve included several application diagrams to help you plan your own system installation. Figures 1 through 4 show how to config- ure the decade series power amplifiers for stereo, bridged-mono and tri-mode operation. (note: for simplicity, figures do not show pow...

  • Page 7

    7 symptom likely cause solution no audio low/no remote on voltage check connections; turn-test turn-on voltage speakers are not connected check wiring; use vom/dvm to measure speaker coil or are blown resistance distorted audio input sensitivity is not set properly see setting input sensitivity on p...

  • Page 8

    Jbl consumer products 250 crossways park drive woodbury, ny 11797 www.Jbl.Com part no. Decampom made in korea specifications da4002 da6502 da3504 da1002 power output, 4 ohms: 2 x 40 watts 2 x 65 watts 4 x 35 watts 2 x 100 watts power output, 2 ohms: 2 x 50 watts 2 x 75 watts 4 x 50 watts 2 x 150 wat...