JBL MR-17 Operation Manual

Summary of MR-17

  • Page 1

    Revised 28 / april / 05 this product is sold and serviced exclusively by prospec electronics inc. And must be returned to prospec for in and out of warranty repairs. It can not be serviced under warranty by other jbl service centers. All products sold and serviced exclusively by prospec electronics ...

  • Page 2

    ¦Ì poor atmospheric conditions - try again later in the day antenna / lead broken or damaged interference on radio power output : 4 x 45 watts power supply : dc + 12v negative ground speaker impedance: 4 ohm tuning range : 530 ~ 1710khz(usa) 522 ~ 1620khz(eur) sensitivity : 35db / uv tuning range : ...

  • Page 3

    Contents 1 2 3 4 5 6 7 8-9 10 11 12 13 contents wiring installing and removing the detachable face important notes installation supporting the unit identification of controls and functions controls station tuning operating the cd & cd changer precautions and maintenance trouble shooting guide & spec...

  • Page 4

    2 11 installation notes applicable to both 2 and 4-speaker connection: a. Connections b. Din cable connection for remote control c. Din cable connection for sirius control d. Aux-in e. Cd changer socket f. Antenna socket this radio contains four separate power amplifiers. To prevent possible damage ...

  • Page 5

    3 10 carrying case front panel 4. Keep the detachable front panel in the protective case provided. 2. Grip the release section and pull the front panel forward. - be careful not to grip the front panel display too tightly or to drop the panel. 3. Close the inner cover. - after removing the front pan...

  • Page 6

    4 9 important notes prior to the final installation, carry out a sound check. If high distortion or intermittent sound is experienced, it is possible that the wiring from the cd receiver to the boat's electrical system is poor or that the battery needs recharging. If the battery and its charging cir...

  • Page 7

    5 8 volume select bass select treble select fader select balance select beep 2nd i-vol area press press press dsp controls 1. Power on/off button (1) push the pwr button (1) to turn on the unit. Push the button again to turn off the unit. 2. Sel and vol button (2) 1) audio control ( volume / bass / ...

  • Page 8

    6 7 identification of controls and functions 1. Power on / off button 2. Electronic function select button, volume decrease or increase button 3. Mode button 4. Sh. Sr (shift / scroll) button (sirius only) 5. Bd / fn button 6. Cd play / pause button, radio preset 1 button 7. Cd intro scan button, ra...