Jbl on air ™ wem-1 transmitter/receiver/amplifier service manual jbl consumer products 250 crossways park dr. Woodbury, new york 11797 rev 1 11/2008.
Service note: wem-1 systems should be exchanged under the warranty period; the electronics are not serviceable down to component level. Order the following parts when needed: mechanical parts see page 7 transmitter part# 015-7600-00031-e receiver/amplifier part# 010-7604-05194-e - contents - basic s...
On air wem-1 2.
Notes: for the sake of simplicity, throughout this manual the term “source” is used when describing connections and operation. This would apply to any device such as an a/v receiver, audio component, computer or portable music player. The jbl on air wem-1 may be connected to your source in several w...
4 on air wem-1.
5 when using the wem-1 to power surround speakers in a home theater system: in this application, the output level of your wem-1 will not only be dependent on the volume setting of your a/v source; it will also need to be properly adjusted after installation and before use in order to be able to work...
Auto on/standby the jbl on air wem-1 will automatically enter the standby mode after approximately 10 minutes, when no signal is detected from your system. The wem-1 will then power on instantly when a signal is detected. When mute is engaged, auto turn-off is deactivated. Normal operation (input on...
On air wem-1 7.
