Ps ps series powered subwoofers owner’s manual ps100 ps120 ps60 ps manual[p].Qxp2 7/27/98 3:24 pm page 2.
2 caution risk of electric shock do not open caution: to reduce the risk of electric shock, do not remove amplifier back. No user servicable parts inside. Refer servicing to qualified service personnel. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert t...
3 introduction congratulations on choosing jbl loudspeakers. Their highly accurate, uncolored and balanced sound character will greatly increase your enjoyment of recorded music. We build jbl speakers with careful attention to detail, using only the highest quality materials. They will provide many ...
"speaker level input (from amplifier)" - use these inputs when connecting to the speaker out (speaker mains) of your receiver/t.V./source amplifier. Run speaker wires from the speaker output terminals (usually coded red and black) on the rear of your receiver/t.V./source amplifier to the red and bla...
5 speaker level output (to external speakers) + r + r l + l + l r crossover frequency level min max 50 200 (hz) polarity reverse normal speaker level input (from amplifier) line input ps subwoofer l r + - + - receiver, tv, or amplifie l r fig. 1: line level input connectio rca phono cables ps manual...
6 speaker level output (to external speakers) + r + r l + l + l r crossover frequency level min max 50 200 (hz) polarity reverse normal speaker level input (from amplifier) line input ps subwoofer l r + - + - receiver, tv, or amplifie l r fig. 2: speaker level input connecti speaker wire ps manual[p...
Your receiver/t.V. / source amplifier to produce the low bass while passing the unaltered signal source to the external speakers. "speaker level output (to external speakers)" - hook up the external speakers using two- conductor insulated wire following the same procedure described under speaker lev...
Speaker level output (to external speakers) + r + r l + l + l r crossover frequency level min max 50 200 (hz) polarity reverse normal speaker level input (from amplifier) line input ps subwoofer l r - + + - receiver, tv, or amplifie l r fig. 3: speaker level output connecti external speakers + - - +...
9 begins to play. The led turns green. After approximately 3 minutes of non-use (no signal being received), your ps subwoofer goes into the auto shut- off mode. The led turns red to signify this stand-by condition. Amber - the led turns amber briefly when the amplifier is in the protection mode. Thi...
Use the polarity switch to maintain proper acoustic summation with the main speakers. Listen to your ps subwoofer and main speakers with the switch on "normal" then listen to the same material with the switch on "reverse". Decide which way sounds better and leave the switch in this position. You sho...
Specifications ps60 ps100 ps120 amplifier power (rms)* 50 watts 50 watts 100 watts low frequency 6-1/2" 10" 12" voice coil diameter 1" 2" 2" cone material polypropylene high high polymer polymer laminate laminate inputs line level line level line level & speaker & speaker & speaker level level level...
P po ps60 jbl consumer products, inc. 240 crossways park west woodbury, ny 11797 8500 balboa blvd. Northridge, ca 91329 800 645 7484 a harman international company part no. 75758 ps manual[p].Qxp2 7/27/98 3:24 pm page 1.
