1. DL manuals
  2. JBL
  3. Speaker System
  4. SCS150SI
  5. Owner's Manual

JBL SCS150SI Owner's Manual

Other manuals for SCS150SI: Service Manual, Service Manual
Manual is about: Surround Cinema Series

Summary of SCS150SI

  • Page 1

    Jbl consumer products 250 crossways park drive, woodbury, ny 11797 8500 balboa boulevard, northridge, ca 91329 800-336-4jbl (4525) (usa only) www.Jbl.Com ©2001 jbl, incorporated. Jbl is a registered trademark of jbl, incorporated. Part no. Ai5139 d e s i g n g o a l : bring the thrill of live perfor...

  • Page 2: 0 M

    X + 0 + y 2 0 m h z d e s i g n g o a l : bring the thrill of live performance and movie sound to the home environment by calling on jbl’s professional engineering leadership. S a t e l l i t e t y p e : titanium-laminate-dome tweeter, sealed enclosure s u b w o o f e r t y p e : bass-reflex enclosu...

  • Page 3: Caution

    R e a d t h i s ! I m p o r t a n t s a f e t y p r e c a u t i o n s ! 2 1. Read instructions. All the safety and operating instructions should be read before the product is operated. 2. Retain instructions. The safety and operating instructions should be retained for future reference. 3. Heed warn...

  • Page 4: I N C L U D E D

    3 i n c l u d e d four satellites for left, right and surrounds. Wall-mount brackets. One center-channel speaker with adjustable support leg. Powered subwoofer. For more than 50 years, jbl has been involved in every aspect of music and film recording and reproduction, from live performances to the r...

  • Page 5

    4 subwoofer surround speakers 5 – 6 ft. Front speakers 0-2 ft. The front speakers should be placed the same distance from each other as they are from the listening position. They should be placed at about the same height from the floor as the listeners’ ears will be, or they may be angled toward the...

  • Page 6

    5 m o u n t i n g o p t i o n s satellites and surrounds on shelves. Wall-mounting attach plate to wall. The brackets should be placed, if possible, so that the screws will fasten into a wooden wall stud. If that is not possible, use properly selected wall anchors. The customer is responsible for pr...

  • Page 7

    6 separate and strip the ends of the speaker wire as shown. Speakers and electronics terminals have corresponding (+) and (–) terminals. Most manu- facturers of speakers and electronics, including jbl, use red to denote the (+) terminal and black for the (–) terminal. The (+) lead of the speaker wir...

  • Page 8

    7 dolby * pro logic * (non-digital) – speaker level use this installation method for dolby pro logic appli- cations (not dolby digital, dts ® or other digital processing), where the receiver/processor does not have a subwoofer output, or a volume-controlled preamp (line-) level output: connect your ...

  • Page 9

    Dolby pro logic (non-digital) – line level 8 use this installation method for dolby pro logic appli- cations (not dolby digital, dts or other digital processing), where the receiver/processor is equipped with a subwoofer output, or a volume-controlled preamp (line-) level output: use rca-type patch ...

  • Page 10: O P E R A T I O N

    9 o p e r a t i o n min max subwoofer level min max subwoofer level move the master power switch (marked “power” ¡) to the “ • ” (on) position to use the subwoofer. The scs150 subwoofer will automatically turn itself on or go into standby (sleep) mode when left in the standby mode (“auto/on” switch ...

  • Page 11

    10 if there is no sound from any of the speakers: • check that receiver/amplifier is on and a source is playing. • check that the powered subwoofer is plugged in, and its power switch ¡ is switched on to the “ • ” position. • check all wires and con- nections between receiver/ amplifier and speakers...

  • Page 12

    11 • in dolby digital or dts modes, make sure your receiver/processor is configured so that the sub- woofer and lfe output are enabled. If there is no sound from the surround speakers: • check all wires and con- nections between receiver/ amplifier and speakers. Make sure all wires are connected. Ma...