JBL SCS500.5 Owner's Manual

Summary of SCS500.5

  • Page 1

    12 scs500.5 system frequency response 30hz – 20khz (–6db) satellites maximum recommended amplifier power 100 watts nominal impedance 8 ohms sensitivity 88db @ 1 watt/1 meter frequency response 100hz – 20khz (–6db) tweeter 1/2" (13mm) titanium-laminate dome, video-shielded midrange dual 3" (75mm) dri...

  • Page 2

    3 2 included thank you for choosing jbl for more than 60 years, jbl has been involved in every aspect of music and film recording and reproduction, from live performances to the recordings you play in your home, car or office. We’re confident that the jbl system you have chosen will provide every no...

  • Page 3

    5 4 speaker placement subwoofer surround speakers 5–6 ft (1.5–1.8m) front speakers 0–2 ft (0–0.6m) the front speakers should be placed the same distance from each other as they are from the listening position. They should be placed at about the same height from the floor as the listeners’ ears will ...

  • Page 4

    7 6 connection tips speaker connections separate and strip the ends of the speaker wire, as shown. The wires sup- plied with the system may already be stripped and tinned for easy insertion into the speaker terminals. You may need to separate the two conductors further in order to thread them throug...

  • Page 5

    9 8 dolby pro logic ® (non-digital) – line level use this installation method for dolby pro logic applica- tions (not dolby digital, dts or other digital processing), where the receiver/proces- sor is equipped with a sub- woofer output, or a volume- controlled preamp (line-) level output: use rca-ty...

  • Page 6

    10 if there is no sound from any of the speakers: • check that receiver/ampli- fier is on and a source is playing. • check that the powered subwoofer is plugged in, and its power switch å is switched on (“•” position). • check all wires and con- nections between receiver/ amplifier and speakers. Mak...