JBSYSTEMS Light LED DIAMOND II Operation Manual - page 6
ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
4/6
LED DIAMOND II
To prevent strange behavior of the light effects, due to interferences, you must use
a 90Ω to 120Ω terminator at the end of the chain. Never use Y-splitter cables, this
simply won’t work!
Make sure that all units are connected to the mains.
Each light effect in the chain needs to have its proper starting address so it knows
which commands from the controller it has to decode. In the next section you will learn how to set the
DMX addresses.
HOW TO OPERATE THE UNIT
YOU CAN OPERATE THE UNIT IN 2 WAYS:
o
Standalone + master/slave using the built-in preprogrammed functions
o
By using any universal DMX controller (1 & 6 channel DMX mode)
STANDALONE MODE:
The effect can work by its own via several build in automatic modes or music controlled modes.
You can choose between:
7 different automatic color modes. The rotation speed can be set at 9 different levels.
2 different sound controlled modes. The rotation speed and color changing will be controlled by the build-in
microphone.
AUTOMATIC MODES:
Connect nothing to the DMX input of the LED DIAMOND
Press the MENU button to browse the different automatic color modes. You can choose one of
the following modes:
o
A1
: red + orange
o
A2
: green + white
o
A3
: blue + purple
o
A4
: alternating colors mode 1
o
A5
: alternating colors mode 2
o
A6
: fading colors
o
A7
: strobe effect
When you have reached the color mode you would like to use, then use the UP and DOWN
buttons to select a rotation speed between 1 and 9.
When the setting of the speed is done, press the ENTER button to confirm.
The LED DIAMOND will now run your selection.
SOUND CONTROLLED MODES:
Connect nothing to the DMX input of the LED DIAMOND
Press the MENU button to browse the different sound controlled modes. You can choose
between the following modes:
o
So 1
:
sound controlled strobe mode
o
So 2
: sound controlled color mode
Press the ENTER button to confirm your choice.
MASTER / SLAVE MODE:
Select this function when you want an instant show. By linking the units in master/slave connection, the first
unit will control the other units to give an automatic or sound activated, synchronized light show.
Connect nothing to the DMX input of the first LED DIAMOND, because this will be the Master Unit.
Select in this Master unit one of the automatic or sound controlled modes like mentioned in the
previous chapter ‘STANDALONE MODE”