Jcb JCB-ID20LIBL Safety And Operating Manual - Operation
JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
OPERATION
1. INSERTING A BIT
HOLDER, SOCKET OR
SCREWDRIVER BIT (See B)
Pull the collet locking sleeve forward.
Fully insert the desired bit into the
chuck to the stop and release the
collet locking sleeve.
2. REMOVING A BIT
HOLDER, SOCKET OR
SCREWDRIVER BIT (See B)
Pull the collet locking sleeve forward.
Take the tool out of the chuck and
release the collet locking sleeve.
3. SWITCH LOCK
The switch trigger can be locked in
the OFF position. This helps to reduce
the possibility of accidental starting
when not in use. To lock the switch
trigger, place the direction of rotation
selector in the center position.
4. REVERSIBLE
For drilling and screw driving use
forward rotation marked “
” (lever
is moved to the left). Only use reverse
rotation marked “
” (lever is
moved to the right) to remove screws.
WARNING: Never change
the direction of rotation
when the chuck is rotating, wait
until it has stopped!
B
3
A
4
B