JCM JCM UAC Operational Instructions
September, 2016
September, 2016
© 2016 JCM American Corporation
© 2016 JCM American Corporation
8
1
Part No. 960-100194R_Rev. 3
®
®
925 Pilot Road, Las Vegas, Nevada 89119
Office & Technical Support: (800) 683-7248 (option 1 after hours), FAX: (702) 651-0214
E-mail: techsupport@jcmglobal.com
http://www.jcm-american.com
JCM is a registered trademark of JCM American Corporation. All other product names
mentioned herein may be registered trademarks or trademarks of their respective companies.
Furthermore,
™
,
®
and
©
are not always mentioned in each case throughout this publication.
JCM UAC
™
Device
Operational Instructions
This document contains information for configuring and operating the JCM
Universal Acceptor Connector
™
(UAC) Device.
The UAC
™
is a TTL and RS-232 to USB Protocol Converter that allows a JCM
Product to directly connect to a PC using its standard USB Communications
Port. JCM Products utilize either an Opto-isolated Current Loop (TTL) or an
RS-232 Protocol for communication.
The UAC
™
eliminates Jumper changing, Power Supply re-configuration, RS-232
Circuit Board removal, or using other complicated harness configurations to
connect a Banknote Acceptor to a Computer for testing operations.
UAC DEVICE KIT PRIMARY COMPONENTS
Figure 1 illustrates the primary component parts of a JCM UAC
™
Kit.
Figure 1
Primary UAC Kit Interconnection Scheme
Typical UBA & iVIZION
Units (Not Included)
Typical EBA & iPRO Units
(Not Included)
Typical TBV & DBV-30x
Units (Not Included)
Typical UAC Installation Equipment & Cable Requirements
Typical Taiko & Vega Units
(Not Included)
Operator Guide