JDS Uniphase VSE-1100 Quick Start Manual
Signal/PowerConnectors
The VSE-1100 is equipped with dual F-connectors for
differential signal analysis and a power input on the left
side. 12VDC power can be supplied to the unit from the
included AC power adapter or 12VDC power cable.
On the right side are the control connectors - a USB
connector for direct atachment to the tablet and an
Ethernet port connector.
WiFi Antenna
A standard WiFI antenna is located on the rear of the unit
and can be repositioned for maximum reception by
rotating as needed.
VSE-1100
Quick Start Guide
What is in the box?
VSE-1100 Basics
VSE-1100 Warnings
JDSU Sales
North America
Tel:
1 855 ASK JDSU (1 855 275 5378)
Latin America
Tel:
+1 954 688 5660
Fax:
+1 954 345 4668
Tel:
+852 2892 0990
Fax:
+852 2892 0770
EMEA
Tel:
+49 7121 86 2222
Fax:
+49 7172 86 1222
JDSU
Technical Assistance Center
Tel:
855 275 5378 / 855 ASK JDSU
Option 3-1-2
email: catvsupport@jdsu.com
VSE-1100
Case
AC Power Cable
and Adapter
12V DC
Power Cable
WARNING
If the equipment is used in a manner not specified
by the manufacturer, the protection provided by the
equipment may be impaired.
WARNING
Do not use this product in the vicinity of a gas leak
or in any other explosive environment.
WARNING ELECTRICAL SHOCK
Electrical shock may result in serious injury or death.
Be sure the AC cord is connected to the correct
voltage mains. Use only the universal power supply
with the test set.
!
!
!
WARNING
Do not disassemble the meter.
Do not attempt to service this product yourself.
There are no user-serviceable parts inside.
Contact the appropriate JDSU representative for
repair or calibration.
22048437-001 Rev003
Input-Upstream
85MHz Only
Input-Upstream/
Downstream
Power
Ethernet Port
USB Conn. 2
Micro-USB
Tablet
Connection
Left side
Right side