JDTECK wcb series User Manual - page 3
2. Features & Functions
– Cont.
3. Installation Procedure
The WCB Series pre-amplifier must be installed between the donor antenna
and the cellular repeater. Do not install on the indoor side of the repeater.
Installing this amplifier in a temperature controlled environment or any
location where there is good ventilation free of moisture or any other heat
source is recommended. An AC power source will be required to power the
unit. The location you choose for the amplifier should allow you to easily
monitor the active LED’s on the side panel.
1. Align pre-amplifier to the position you have selected for it. Double check
your distance between the pre-amplifier and the repeater to ensure your
jumper cable mating these two devices is long enough.
2. Mark the position, drill holes for the mounting screws and affix in position.
3. Connect RF cables and power cables to the pre-amplifier respectively.
The donor antenna coax must connect with the
“Outdoor” port of the
pre-amplifier, whereas the
“Indoor” port of the pre-amplifier must
connect with the
“Outdoor” port of the repeater.
4. After installing the pre-amplifier as described as above, power on the pre-
amplifier and cellular repeater to check the LED operation status.
RF Port
RF Port
Mounting Slot
(Optional SMA Model Type)