Jeanneau 53 Owner's Manual - page 87
83/154
119635
Index G
SEWAGE
USE OF THE MARINE HEADS
Before you use the heads, check that the water intake valve and draining valve are
open.
To empty the bowl:
- Set the control lever of the pump slantwise (FLUSH).
- Operate the pump.
To dry the bowl:
- Set the lever back vertical (DRY).
- Operate the pump.
To avoid blocking the toilets only use absorbent paper in reasonable quantities.
Schedule a regular rinsing through of the heads with fresh water.
Close the valves after each use (in particular when the boat is unattended).
ELECTRIC TOILET
The electric toilets operate with seawater only. A switch enables the water intake and drain
cycle of the bowl to be activated. A switch enables the bowl to be rinsed.
WARNING
- The tanks' nominal capacity cannot be fully used due to the load and the
need to maintain the correct trim. A 20% reserve should be kept
ADVICE - RECOMMENDATION
- When you are in a marina, use the club-house sanitary facilities (if there are).
- Since it is prohibited to discharge sewage water in certain marinas or countries it may
be necessary to use the foul water holding tank ('WHT').
Pump - 12V electric toilet
Location:Under cabinet bathroom
Control
8
W
A
T
E
R
A
N
D
S
E
W
A
G
E
W
A
T
E
R