Jeanneau LEADER 9 Owner's Manual - page 31
of
106
27/102
ELECTRIC BILGE PUMP
Operation:
The electric bilge pumps are connected to the 12V service circuit. To enable operation the
12V circuit must be activated by turning on the battery switches.
You can energize the electric bilge pump from the electrical panel.
On the electrical panel - three possible positions : OFF / Automatic / Mechanically
operated.
In the automatic position each pump is set off automatically by a trip switch located in the
sump area or in the bottom of the hull.
Control
Electric bilge pump 12V
Location: Plumbing board
Capacity: 15 litre / minute
Electric bilge pump 12V
Location: Engine compartment
Capacity: 35 litre / minute
Electric bilge pump 12V
Location: Under the companionway
Capacity: 50,5 litre / minute
2
S
A
F
E
T
Y