Jeanneau LOISIRS Owner's Manual - Launching
81/88
HOISTING
- Install a fore rope, a rear rope and fenders.
- When hoisting, check that no device is crushed by the belts (sounder, speedometer etc.).
- Mark the belt position with adhesive tape on the rubrail. The belt position will be useful during the
craning for a future launching.
- The crane hook will be fitted with a gantry or a spacer with two belts. The belts shall not be hooked
directly on the hook, since it would result in unusual compressive stresses on the hull.
- Hoist slowly. Control the movement of the boat with ropes.
AFTER LAUNCHING
- Check the sounder and speedometer fittings for tightness if need be.
- Open the valves and make sure that they are tight with the hull and relevant hose.
- Check the stuffing box for watertightness (Refer to chapter 8: "Stuffing box").
- Before starting the engine, refer to chapter 8 "Engine".
WARNING
Do not stay on board or under the boat during hoisting.
9