Jeanneau SUN ODYSSEY 36I Owner's Manual - Hull
25/116
CONSTRUCTION
Your boat is built in GRP.
The inner moulding that is stuck and laminated to the hull distributes the stresses over the
whole bottom surface. The iron ballast is fastened to the hull with bolts and backing plates.
The deck is made of sandwich balsa with inserts for the deck fittings. The deck to hull joint is
made of a polyurethane filler and it is reinforced by the fastening of the teak foot strap.
MAINTENANCE OF THE HULL
The materials and equipments of your boat have been selected because of their high quality
and performance and ease of maintenance. However you shall carry out a minimum
maintenance in order to protect your boat from outside attacks (salt, sun, electrolysis ...).
Preferably wash your boat on shore.
Use as few cleaning agents as possible.
Don't use aggressive detergent agents or solvents (read next page).
Don't discharge cleaning agents into the water.
PRECAUTION
We strongly advise you against using a pressure washer.
You shall not use hot water or steam.
3