Jeanneau Sun odyssey 509 User Manual - page 7
Preliminary Specifications and Inventory - Subject to modification - July 2011.
TRIM LEVEL PREFERENCE
•
Vertical stainless steel door for fridge compartment
•
1 Harken 46.2 Electric winch on the coachroof for halyards and control lines, 12v
•
Linear drive unit for aft platform motorises raising and lowering platform
•
Dock water inlet with pressure regulator. Allows the use of onboard systems without using water in the
tanks when at the dock
PACKS
electronic
pack
•
1 Transducer for speed and depth in the hull
•
1 Wind sensor at masthead
•
1 Raymarine st70 display at starboard helm
•
1 Raymarine st70 display on the cockpit table
performance
plus
pack
•
Below deck genoa furler with furling line led to cockpit
•
140% Genoa triradial cut Mylar/taffeta X-Grid laminate in grey
•
Mainsail full-batten, triradial cut Mylar/taffeta X-Grid laminate in grey
•
Hydraulic backstay adjuster with linear ram
•
Long genoa tracks on side decks with ball-bearing cars and control lines led aft to cockpit
•
Upgraded genoa winches 70.2 self-tailing winches (note: electric winches remain in 60.2 size)
•
Folding propeller Flex-o-Fold
•
Standing rigging is Dyform discontinuous wire rigging
•
Running rigging is low-stretch Dyneema
performance
self
-
tacking
pack
•
Self-tacking jib triradial cut Mylar/taffeta X-Grid laminate in grey
•
Mainsail full-batten, triradial cut Mylar/taffeta X-Grid laminate in grey
•
Hydraulic backstay adjuster with linear ram
•
Track for jib in front of the mast with ball-bearing car
•
Folding propeller Flex-o-Fold
•
Standing rigging is Dyform discontinuous wire rigging
•
Running rigging is low-stretch Dyneema
MAST AND SAIL
•
Running rigging for asymmetrical spinnaker / code 0 includes:
- 2 sheets
- 1 halyard
- 1 downhaul
- Turning blocks for mast base and sidedecks
•
Running rigging for symmetrical spinnaker includes:
- 2 sheets
- 2 guys
- 1 halyard
- Track and inboard end car for the front of the mast
- Blocks for running rigging
- Spinnaker pole that stores on the mast
•
Releasable forestay for staysail (option not compatible with self-tacking jib)
•
Furling mast aluminium mast with double spreaders (option not compatible with Performance packs)
•
2 Harken 60.2 Electric winches located near helm consoles for genoa and mainsheets, 12V
•
Code 0 with continuous line furlerand 2:1 halyard. Designed for light air use for beam and broad reaching.
The sail is made of a Mylar/Aramid laminate
•
Windex 15
DECK AND HULL
•
Teak battens on cockpit floor
•
Teak deck
•
Wooden rubrail located just below deck edge
•
Painted hull for colour selection see price list
EXTERIOR EQUIPMENT
•
Bracket for outboard motor mounted on pushpit
•
Folding teak cockpit table replaces GRP cockpit table with all the same functions
•
Composite steering wheels black, replaces standard wheels
•
Bow thruster 24V 11.5HP with separate 24V OPTIMA REDTOP battery bank
EXTERIOR CANVAS
•
Wide sprayhood in Sunbrella
®
•
Protective covers for steering wheels
•
Protective cover for cockpit table
•
Large 4 bow cockpit bimini with viewing ports above each helm that can be folded back and out of the
way when not in use.
•
Cockpit cushions with closed-cell foam and covered in Sunbrella
®
PASSERELLE AND LADDERS
•
Boarding ladder for lifeline gates
•
Hydraulically operated gangway on transom