Jeep Baby Traveller Instructions Manual - page 5
Manual is about: 4-Wheel Stroller
of
16
4
To Assemble Rear Wheels
Turn stroller over as shown.
Position rear axle assembly as shown, with red
brake levers pointing towards stroller handle.
Push rear axle assembly onto rear leg tubes
at the same time.
Make sure plastic tabs on rear axle lock into
holes on rear legs as shown.
Slide a wheel onto the axle then slide a
washer onto the axle.
Fit straight part of cotter pin through hole on
axle as shown.
Line up each of the tabs in the hub cap with
the slots in the wheel, snap hub cap into
place.
Repeat for second side.
1
2
1 & 2
4
4
5
Tab locks into hole
5
6
3
7
6
8
S67-R1.qxd 1/17/2006 11:30 AM Page 5