Jeep COMPASS 2018 Quick Reference Manual - page 6
To Activate
Push the on/off button. To turn the system off,
push the on/off button a second time. The
system should be turned off when not in use.
To Set A Desired Speed
Turn the Speed Control on. When the vehicle has
reached the desired speed, push the SET (-) or
SET (+) button and release. Release the accelera-
tor and the vehicle will operate at the selected
speed.
To Deactivate
A soft tap on the brake pedal, pushing the CANC
button, or normal brake pressure while slowing the
vehicle will deactivate Speed Control without eras-
ing the set speed memory. Pushing the on/off
button or turning the ignition switch OFF erases
the set speed in memory.
To Resume Speed
To resume a previously set speed, push the RES
button and release.
To Increase Speed
When the Speed Control is set, you can in-
crease speed by pushing the SET (+) button.
To Decrease Speed
When the Speed Control is set, you can de-
crease speed by pushing the SET (-) button.
To Accelerate For Passing
Press the accelerator as you would normally.
When the pedal is released, the vehicle will
return to the set speed.
For further information, and applicable warn-
ings and cautions, please refer to the Owner’s
Manual
at
www.mopar.com/en-us/care/
owners-manual.html
(U.S.
Residents)
or
www.owners.mopar.ca (Canadian Residents).
ParkSense Rear Park Assist — If
Equipped
• The four ParkSense sensors, located in the
rear fascia/bumper, monitor the area behind
the vehicle that is within the sensor’s field of
view.
ParkSense Switch
PARKSENSE