Model 7 mono amplifier owner’s manual table of contents introduction features unpacking instructions installation * space requirements * a.C. Connections input impedance selection adjustable gain signal connections * single-ended input configuration * differential mode input configuration basic trou...
Introduction congratulations on your purchase of the jeff rowland design group model 7 mono amplifier. Please take a few moments to read this owners manual. Contrary to popular belief, there is actually quite a bit of useful information in an owners manual. The model 7 offers tremendous interconnect...
We strongly suggest that you save all packing materials remove the foam pieces which protect the top of the amplifier. The amp can be lifted out of its crate while still wrapped in the plastic bag. In the case of the model 7 amplifier, do not attempt to move it alone! This amp is extremely heavy. In...
The "low" setting is for use with most direct-coupled solid-state preamplifiers such as those made by jeff rowland design group; the "medium" setting is for use with most solid-state, hybrid and some tube preamplifiers; the "high" setting is for use with most tube preamplifiers. We have provided the...
• remote power switch connector • right and left channel inputs (single-ended non-inverting, single-ended inverting and differential inputs) • right and left channel input impedance adjust • ac power switch • ac power connector • ac line fuse operation with a single-ended output preamplifier for sta...
Technical specifications output power 350 watts rms continuous, 8 ohms 700 watts rms continuous, 4 ohms 1100 watts rms continuous, 2 ohms power bandwidth 0.15 hz to 175 khz, -3 db slew rate 50 volts per microsecond thd and noise less than .015%, 1 khz, 8 ohms, 20 watts less than .045%, 1 khz, 8 ohms...
