JEHNERT SOUND DESIGN AUDI 80 convertible Installation Instructions Manual

Manual is about: Car-Audio-Systems

Summary of AUDI 80 convertible

  • Page 1

    Sound sound d e s i g n jehnert a u d i 8 0 c on ve rt ib le / c ou pé g u a r a n t e e ☞ without co-passenger airbag 2002/by.Aj/fh - 15 - installation instructions in st al .I n st r. I te m -n o . 7 6 1 5 0 /f h 1 0 /0 2 item-no. 76150 jehnert sound design development and production of car-audio-...

  • Page 2: C O N T E N T S

    Packing list .......................................................................... 1. Disassembly of the door lining .............................................. 2. Insulation of the door lining / car doors ................................ 3. Panel alignment / reference points ..................

  • Page 3: Packing List

    Packing unit check list door panel, covered (right / left) speaker grill, covered (right / left) tweeter 26 mm tweeter mounting bowl ( with 6ktn.Screw m4x8 u. Washer ø12mm) midrange 100 mm q assembly ring woofer 160 mm (each mounted on the panel with 2 sheet metal-screws) crossover (right / left) st...

  • Page 4

    Removing the grills: the velcro fasteners stick together very strongly! The grills can be removed anytime by carefully lifting them off. Please, avoid any way of forceful yanking at the grills. It could break! 9.3. 9.2. Our tip: if the panel cannot be pressed on completely at some points. . . Cause:...

  • Page 5

    Lautsprecheranschluss - schaltbild alle lautsprecher und frequenzweichen anschließen: h i g h p e r f o r m a nc e d e s i g n jehnert sound sound m i d r a n g e s p e a k e r m a d e i n g e r m a n y lautsprecheranschluss - schaltbild alle lautsprecher und frequenzweichen anschließen: h i g h p e...

  • Page 6: 3 . Panel Alignment

    8. Crossover circuit - speaker connection 8.1. Connect all loudspeakers with the included standart cables for woofer parallel wiring see diagram on page 11. Notice: you should check the polarity of all subwoofers before connecting them to the crossover circuit with a 9 volt battery: pole of the cros...

  • Page 7

    7. Installation of the door lining onto car door 7.1. Fit the door lining in contrary order (described on page 3). 7.2. Cut out the foamed foil like a u (behind the woofers) in order to improve the acoustic link to the door volume. 1. Use the precisely aligned as pattern for the positioning of faste...

  • Page 8: 5.2.

    5.1. Tweeter installation – dashboard: i nsert tweeter bowl instead of the air valves in the dashboard: (this does not affect the ventilation) 5.1.1. Remove the lid of the air valve 5.1.2. Drill a small hole into the ventilation duct for the speaker cable 5.1.3. Connect tweeter with cable (1,5 - 4 m...

  • Page 9: 5.2.

    5.1. Tweeter installation – dashboard: i nsert tweeter bowl instead of the air valves in the dashboard: (this does not affect the ventilation) 5.1.1. Remove the lid of the air valve 5.1.2. Drill a small hole into the ventilation duct for the speaker cable 5.1.3. Connect tweeter with cable (1,5 - 4 m...

  • Page 10

    7. Installation of the door lining onto car door 7.1. Fit the door lining in contrary order (described on page 3). 7.2. Cut out the foamed foil like a u (behind the woofers) in order to improve the acoustic link to the door volume. 1. Use the precisely aligned as pattern for the positioning of faste...

  • Page 11: 3 . Panel Alignment

    8. Crossover circuit - speaker connection 8.1. Connect all loudspeakers with the included standart cables for woofer parallel wiring see diagram on page 11. Notice: you should check the polarity of all subwoofers before connecting them to the crossover circuit with a 9 volt battery: pole of the cros...

  • Page 12: Loudspeaker Wiring Diagram

    Loudspeaker wiring diagram connect all loudspeakers and crossover circuits: h i g h p e r f o r m a nc e d e s i g n jeh nert sound sound m i d r a n g e s p e a k e r m a d e i n g e r m a n y loudspeaker wiring diagram connect all loudspeakers and crossover circuits: h i g h p e r f o r m a nc e d...

  • Page 13

    Removing the grills: the velcro fasteners stick together very strongly! The grills can be removed anytime by carefully lifting them off. Please, avoid any way of forceful yanking at the grills. It could break! 9.3. 9.2. Our tip: if the panel cannot be pressed on completely at some points. . . Cause:...

  • Page 14: Packing List

    Packing unit check list door panel, covered (right / left) speaker grill, covered (right / left) tweeter 26 mm tweeter mounting bowl ( with 6ktn.Screw m4x8 u. Washer ø12mm) midrange 100 mm q assembly ring woofer 160 mm (each mounted on the panel with 2 sheet metal-screws) crossover (right / left) st...

  • Page 15: C O N T E N T S

    Packing list .......................................................................... 1. Disassembly of the door lining .............................................. 2. Insulation of the door lining / car doors ................................ 3. Panel alignment / reference points ..................

  • Page 16: I 8

    Sound sound d e s i g n jehnert a u d i 8 0 c on ve rt ib le / c ou pé g u a r a n t e e ☞ without co-passenger airbag 2002/by.Aj/fh - 15 - installation instructions in st al .I n st r. I te m -n o . 7 6 1 5 0 /f h 1 0 /0 2 item-no. 76150 jehnert sound design development and production of car-audio-...