Installation instructions over the range microwave oven before you begin read these instructions completely and carefully. • important – save these instructions for local inspector’s use. • important – observe all governing codes and ordinances. • note to installer – be sure to leave these instructi...
Installation instructions 2 contents general information important safety instructions .....................3 electrical requirements ..............................3 hood exhaust ...........................................4, 5 damage – shipment/installation .................6 parts included............
Installation instructions 3 important safety instructions this product requires a three-prong grounded outlet. The installer must perform a ground continuity check on the power outlet box before beginning the installation to insure that the outlet box is properly grounded. If not properly grounded, ...
Installation instructions 4 hood exhaust note: read these next two pages only if you plan to vent your exhaust to the outside. If you plan to recirculate the air back into the room, proceed to page 11. Outside top exhaust (example only) the following chart describes an example of one possible ductwo...
Installation instructions 5 note: if you need to install ducts, note that the total duct length of 3¼" x 10" rectangular or 6" diameter round duct should not exceed 60 equivalent feet. Outside ventilation requires a hood exhaust duct. Read the following carefully. Note: it is important that venting ...
Installation instructions 6 damage – shipment/ installation • if the unit is damaged in shipment, return the unit to the store in which it was bought for repair or replacement. • if the unit is damaged by the customer, repair or replacement is the responsibility of the customer. • if the unit is dam...
Installation instructions 7 tools you will need # 1 and #2 phillips screwdriver level safety goggles stud finder or hammer (optional) saw (saber, hole or keyhole) gloves scissors (to cut template, if necessary) pencil filler blocks or scrap wood pieces, if needed for top cabinet spacing (used on rec...
Installation instructions 8 a. Removing the microwave oven from the carton/ removing the mounting plate 1. Remove the installation instructions, exhaust adaptor, filters, glass tray and the small hardware bag. Do not remove the styrofoam protecting the front of the oven. 2. Fold back all 4 carton fl...
Installation instructions 9 c. Determining wall plate location under your cabinet your cabinets may have decorative trim that interferes with the microwave installation. Remove the decorative trim to install the microwave properly and to make it level. The microwave must be level. Use a level to mak...
Installation instructions 10 d. Aligning the wall plate 1. Draw a vertical line on the wall at the center of the 36" wide space. 2. Draw a horizontal line on the wall at the bottom of “rear wall template”. 3. Drill 5/8" holes for toggle bolts on 3 locations (hole a, hole b, hole c) but if the locati...
Installation instructions 11 2. Installation types (choose a, b or c) this microwave oven is designed for adaptation to the following three types of ventilation: a. Recirculating (non-vented ductless) b. Outside top exhaust (vertical duct) c. Outside back exhaust (horizontal duct) note: this microwa...
Installation instructions 12 a. Recirculating (non-vented ductless) a1. Attach the mounting plate to the wall attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud. 1. Remove the toggle wings from the bolts. 2. Insert the bolts into ...
Installation instructions 13 a3. Mount the microwave oven for easier installation and personal safety, we recommend that two people install this microwave oven. Important: do not grip or use handle during installation. Note: if your cabinet is metal, use the nylon grommet around the power cord hole ...
Installation instructions 14 b. Outside top exhaust (vertical duct) b1. Attach the mounting plate to the wall attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud. 1. Remove the toggle wings from the bolts. 2. Insert the bolts into ...
Installation instructions 15 b2. Use top cabinet template for preparation of top cabinet you need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor. • read the instructions on the top cabinet template. ...
Installation instructions 16 after: fan blade openings facing upward 5. Place the blower unit back into the opening. Caution: do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. 6. Secure blower unit to microwave with the screw. B4. Installation procedure for exhaust ...
Installation instructions 17 b5. Mount the microwave oven (cont.) 4. Attach the microwave oven to the top cabinet. 7. Tighten the outer two screws to the top of the microwave oven. (while tightening screws, hold the microwave oven in place against the wall and the top cabinet.) 8. Install grease fil...
Installation instructions 18 c. Outside back exhaust (horizontal duct) c1. Preparing the rear wall for outside back exhaust you need to cut an opening in the rear wall for outside exhaust. • read the instructions on the rear wall template. • tape it to the rear wall. • cut the opening, following the...
Installation instructions 19 knockouts parts”a” c2. Attach the mounting plate to the wall (cont.) to use toggle bolts: 3. Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. Note: before tightening toggle bolts and wood screw, make sur...
Installation instructions 20 6. Place the blower unit back into the opening. Caution: do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. Note: the blower unit exhaust openings should match exhaust openings on rear of microwave oven. 7. Secure the blower unit to the m...
Installation instructions 21 c5. Mount the microwave oven (cont.) install grease filters. See the owner’s manual packed with the microwave. 4. Attach the microwave oven to the top cabinet. 7. Tighten the outer two screws to the top of the microwave oven. (while tightening screws, hold the microwave ...
Installation instructions 22 before you use your microwave 1. Make sure the microwave oven has been installed according to instructions. 2. Remove all packing material from the microwave oven. 3. Install turntable and ring in cavity. 4. Replace house fuse or turn breaker back on. 5. Plug power cord ...
Installation instructions 23 note.
Part no. : 8101p659-60 form no. : code no. : de68-03118a.