K&D G20 User Manual - page 4

Important. Gate must be installed in a

structurally sound opening. Hinge side of

gate must be mounted to a rigid surface.

Ensure mounting surface (wall, door frame,

stairpost etc.) is strong, rigid and has an even

surface.

If using gate on a stairway, it must be placed

either on top stair or on lowest stair at the

bottom.

Mounting Hinge Side

Screws provided are for mounting directly

into wood. If mounting into brick, drywall

or other surfaces, use appropriate hard-

ware. If installing into hardwood

(i.e. oak), drilling a pilot hole may be

necessary.

Hold template (a) against mounting surface,

making sure end marked 

 is even with

floor.

Mark 4 screw hole positions.

Remove template.

Using 2 wood screws (q) and only lower

screw holes, mount hinge bottoms (b) with

posts pointing up. Top screw holes will be

used later.