K&M Analog Designs LTD Owner's Manual - K&m
FRONT PANEL FUNCTIONS
1. INPUT JACK- High impedance input to the amplifier. Plug in your
instrument here.
2. TREBLE CONTROL- Adjusts the high-frequency response. In the full
counter-clockwise position, high frequencies are bypassed to ground. In the
full clockwise position, high frequencies are allowed to pass to the next gain
stage.
3. MIDDLE CONTROL- Adjusts the mid-range response. In the full counter-
clockwise position, the tone will be somewhat “scooped” of mid-range
response, emphasizing the highs and lows. In the full clockwise position,
mid-range frequencies are allowed to pass to the next gain stage.
4. BASS CONTROL- Adjusts the bass response. In the full counterclockwise
position, low frequencies are cut. In addition, the response of the treble and
mid-range controls is greatly reduced. In the full clockwise position, low
frequencies are allowed to pass to the next gain stage.
5. BRIGHT SWITCH- Boosts the high frequency response. This is most
effective when the input gain is set at 12 o’clock or lower. The effect is less
dramatic as the input gain control is adjusted past the 12 o’clock position.
6. MID SWITCH- The mid boost function is assignable to either the clean or lead
channel, or off. The center position is off. In the "DOWN" position, the mid
boost is engaged whenever the clean channel is selected. In the "UP"
position, the the mid boost function is engaged whenever the lead channel is
selected.
7. DEEP SWITCH- Boosts the low and low-mid frequencies. This is a low
frequency contour switch, changing the low and low-mid response.
Page 2
K&M
LTD
MIDDLE
BASS
MID
DEEP
BRIGHT
EQ1
LEAD
BYPASS
LEAD GAIN
REVERB PRESENCE
L EAD MASTER
GAIN
MASTER
INPUT
TREBLE
EQ2
STANDBY
1
2
3
4
5
6
7
8
9
10
11
12
13 14
15 16
17
18
ON
LEAD
CLEAN