K&M Analog Designs Two-Rock Topaz Owner's Manual

Summary of Two-Rock Topaz

  • Page 1

    Input presence two-rock two-rock topaz owner's manual.

  • Page 2: Two-Rock

    Page 1 thank you for your purchase of a two-rock amplifier from k&m analog designs, llc. As a discerning guitarist, you know the road to great tone begins with great components. Our classic design, carefully selected parts and hand-built approach combine to make an extremely versatile instrument. Pl...

  • Page 3: Front Panel Functions

    Front panel functions 1. Input jack- high impedance input to the amplifier. Plug in your instrument here. 2. Treble control- adjusts the high-frequency response. In the full counter- clockwise position, high frequencies are bypassed to ground. In the full clockwise position, high frequencies are all...

  • Page 4

    10. 2rock/hi-fi- this switch allows you to choose between 2 completely different equalization setting. Hi-fi is a lower gain setting, with extended midrange and bass available when used in conjunction with the middle and bass controls as well as the deep switch. This setting is suitable for any styl...

  • Page 5: Rear Panel Functions

    Rear panel functions 1. A/c input- connects the amplifier to a/c power via the power cord supplied. Unless otherwise specified, your amplifier is designed to operate on 120 volts a/c, 60 cycles. 2. Fuse- 3 ag type, slow blow fuse. Refer to the legend below the fuse holder for the proper fuse rating ...

  • Page 6

    7. Effects return- use this jack to connect the output of your effects to the amplifier. 8. Effects level- adjusts the return signal level. It also acts as a master volume control. Do not set fully counter-clockwise, as this will shut off signal to the output section, resulting in no output level. N...

  • Page 7: Foot Switch

    Foot switch tube complement v1- 12ax7, rhythm channel v2- 12ax7, lead channel v3- 5751, reverb driver v4- 12ax7, reverb / effects v5- 12ax7, phase inverter v6, v9- 7581, output v7, v8- 7581, output (100 watt only) tubes are numbered from right to left as you face the rear of the amp. Each fine produ...

  • Page 8: K & M Analog Designs

    K & m analog designs amplifiers are brought to you by bill krinard and joe mloganoski. We know your new two-rock amplifier will provide many hours of enjoyment and inspiration in the years to come. This manual is a resource for some of your questions. Please contact us with any other questions or co...

  • Page 9: K & M Analog Designs

    This is a product of k & m analog designs 7880 old redwood highway cotati, ca 94931 serial number:___________.