K'Nex Mikey's Swing-Arm Bike 12009 Instructions Manual - K’Nex B
“
Hi! I’m your K’NEX Building Buddy. When you
see me in the instructions, you’ll want to pay
close attention to the details being pointed out.”
Ready, Set, Build
To begin your model, find the and follow
the numbers. Each piece has its own shape and
color. Just look at the picture, find the pieces in
your set that match what you see, and snap
them together. Try to hold your model in the
same direction as in the picture so you’ll attach
your pieces to the right place.
Movin’ On
The faded colors tell you this section is
already built. You’ll want to connect the
new section to the place where the arrows
are pointing. These pieces will be in full
color.
Cross - snap
When a Connector snaps on across a Rod, it is referred
to as a “cross-snap”. Cross-snaps sometimes require a
strong push and you might want to ask an adult for
help.
FCC Statements:
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including
interference that may cause undesired operation. This model is
tested to comply with FCC standards - FOR HOME OR OFFICE USE.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy, and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures: (1) Reorient or relocate the receiving
antenna. (2) Increase the separation between the equipment and
receiver. (3) Consult the dealer or an experienced radio/TV technician.
This Class B digital apparatus complies with Canadian ICES-003.
4
4
BUILDING TIPS:
•
Try to face your model in the same direction as shown in
the instructions.
•
Some steps include pieces that require a strong “push” to
snap together. You might want to ask an adult for help.
1
K’NEX B
UILDING
B
ASICS
K’NEX B
UILDING
B
ASICS
1
2
1