K-Star K-5 Instruction Manual

Page of 4

Download

Bookmark us

READ AND FOLLOW ALL INSTRUCTIONS

1a)

K-Star Heater may be installed indoors or outdoors at least 6”

from any object. Ensure that the installation allows access for electrical

and plumbing connections and that the Thermostat control is

conveniently located.

The installation of current leakage collectors should be done as

per Figure 01 before permanently positioning Heater.

Heater must be installed after the filter and before the Air Injector

or Automatic Chlorinator.

A leakage current collector must be installed at the water inlet,

and another at the outlet of the unit, and these shall be electrically

insulated from the unit. The installation of the collectors shall be

such that all water entering and leaving the unit flows through the

two collectors, as shown in Figure 01. The length of the leakage current

collectors shall be made of a corrosion resistant metal and shall be

provided with a copper lug brazed to the collector body.

Hand tighten only. Do not use high force with a pipe wrench.

FIGURE 01. LEAKAGE CURRENT COLLECTOR DIAGRAM

The Heater shall be installed as per Figure 02. The water inlet and outlet

are connected to straight connectors of the heater.

FIGURE 02

361 Rowntree Dairy Road, Unit 4

Woodbridge, ON Canada L4L 8H1

Tel: 905.264.6496 Fax: 905.264.6508

Email: consolidatedpool@bellnet.ca

INSTRUCTION MANUAL

“K-STAR” ELECTRIC

POOL & SPA HEATERS

APPROVED LR 51670

MODELS:

K-5 / K-10 / K-15

KS-5 / KS-10

1 2 3 4 Next › »

Page 1
Read and follow all instructions 1a) k-star heater may be installed indoors or outdoors at least 6” from any object. Ensure that the installation allows access for electrical and plumbing connections and that the thermostat control is conveniently located. The installation of current leakage collect...
Page 2
2 a) electrical: electrical work must be performed by a qualified electrician and comply with the canadian electrical code or the american national standard electrical code lnforce. Table 02. The wire sizes to be used are as follows: for installation see wiring schematic figure 03. Figure 03. Wiring...
Page 3
6 2. Apply electric power to the heater, then rotate the thermostat control clockwise to the max. Position. The red indication lamp will be lit when the heater is on. 3. After the desired temperature is reached, re-adjust the thermostat control to suit your requirement. The scale ranges from 70 to 1...
Page 4
8 warranty (for the original owner only) k-star pool heater is guaranteed for a period of one year from the date of its purchase to the original owner against any manufacturing defects. Any warranty claim must be pre-authorized by consolidated pool & spa industries inc., and claim must include the s...