Read and save this instructions for domestic cooking only installer: leave this manual with the homeowner. Homeowner: cleaning, maintenance and operating instructions on the coming pages. Range hood item no.: k1012/k1012a refered model no.: 3503a/3503d number: e312110
Intended for domestic cooking only warning to reduce the risk of fire, electric shock, or injury to persons, observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warra...
Caution 1. To reduce risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. 2. Take care when using cleaning agents or detergents. 3. Avoid using food products that produce flames u...
Prepare the hood unpack hood and check contents. You should receive: 1 - hood 1 - decorative flue assembly 1 - parts bag containing: 1 - mounting bracket 1 - installation instructions 1 - vent 1 - warranty card 1 - duct fixing support 2 - safety screws (st4mm x30mm) 1 - slidery duct fixing support 7...
Warning stall the ductwork ote: this range hood must be properly n grounded. The unit should be installed by a qualified electrician in accordance with all applicable national and local electrical codes. The minimum hood distance above cooktop must not be less than 24’’. A maximum of 33” above cookt...
Install mounting brackets after eveluating the height of the hood, place the hook center over installation location. Drill 3 holes of Ø8mm on a suitable place to fix the mounting brackets. Put the drywall anchors into the holes and fix the mounting screws (4x50mm) into the anchors, and install the h...
None-ducted recirculation filter installation purchase a non-ducted recirculation filter from your dealer. Install the filter by rotating it onto the two 1. 2. Equipment which is stands on sides of the motor. Re p pare the hood screw: 4x8mm note: on stainless steel hoods, y remove the plastic otecti...
Install the hood opening on the back of the hood with the wall-mounting bracket. Gently lower the hood until it securely engages the bracket. Open the al. Filter and find the two φ8 mm holes on the back of the hood. Level the hood with 2 mounting screws (4*35mm) with washer. Use drywall anchors prov...
Maintenance oper maintenance of the range hood will sure proper performance of the unit. Nce display goes on or starts blinking). Se a warm detergent solution. Grease filters are leaning tips: hot water with soap or detergent is all that is usually needed. Follow all cleaning by rinsing with clear w...
Operation controls always trun the hood on before cooking in order to establish an air flow in the kitchen. After button) turing off the range, let the hood run for a few minutes to clear the air. Tronic button(brighting words button and bl elec ue ring 1. Power: when power-on ,the output is off ,...
Halogen bulbs always switch off the electricity efore carrying out any tt max, o not touch replacement ed lights supply b o perations on the appliance. To change bulbs: 1. Rotate the cover in anticlockwise, as shown. Caution: bulb may be hot,please rotate when the bulb is cool! 2. Replace with a typ...
K-star international group inc. K-star electronic appliance inc. Toll free:(800) 893-2168 email:info@kstarus.Com http://www.Kstarus.Com.
