Read and save this instructions for domestic cooking only installer: leave this manual with the homeowner. Homeowner: cleaning, maintenance and operating instructions on the coming pages. Range hood item no.: k1022/k1022a refered model no.: 3502c1 motor with ul certificate number: e312110
Intended for domestic cooking only to reduce the risk of fire, electric shock, or injury to persons, observe the following: warning 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warra...
1. To reduce risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. Caution 2. Take care when using cleaning agents or detergents. 3. Avoid using food products that produce flames u...
Prepare the hood 1 - vent 1 - warranty card unpack hood and check contents. You should receive: 1 - hood 1 - decorative flue assembly 1 - parts bag containing: 1 - mounting bracket 1 - installation instructions 1 - duct fixing support 2- safety screw (st4mm x30mm) 1 - slidery duct fixing support 7 -...
Warning note: this range hood must be properly grounded. The unit should be installed by a qualified electrician in accordance with all applicable national and local electrical codes. The minimum hood distance above cooktop must not be less than 24’’. A maximum of 33” above cooktop is highly recomme...
Install mounting brackets 1. After evaluating the height of the hood, place the hook center over installation location. Drill 3 holes of Ø8mm on a suitable place to fix the mounting brackets. 2. Put the drywall anchors into the holes and fix the mounting screws (4x50mm) into the anchors, and install...
1. Purchase a non-ducted recirculation filter from your dealer. None-ducted recirculation filter installation 2. Install the filter by rotating it onto the equipment which is stands on two sides of the motor. Prepare the hood note: on stainless steel hoods, carefully remove the plastic protective fi...
Install the hood note: at least two people will be required to mount the hood. 1. Raise the hood into its mounting position. 2. Align the rectangular opening on the back of the hood with the wall-mounting bracket. Gently lower the hood until it securely engages the bracket. 3. Open the baffle filter...
Proper maintenance of the range hood will assure proper performance of the unit. Maintenance filters the filters must be cleaned approximately once every 30 hours of operation (when the central segment on the display goes on or starts blinking). Use a warm detergent solution. Filters are dishwasher ...
Operation controls always trun the hood on before cooking in order to establish an air flow in the kitchen. After turing off the range, let the hood run for a few minutes to clear the air. lcd switch 1. Power on: switch on the power supply, and the backlight is lit, displaying “24-hour system”. Th...
Is null and void. A) press timer key, enter the setting display. 1 st time setting is 5 min. Use speed key for increase gradually, use lamp key for decrease gradually, the time should be set 1:00—60:00 min. Finish setting, press timer key to confirm. B) example: let the setting time be 5min, the dis...
K-star international group inc. K-star electronic appliance inc. Toll free:(800) 893-2168 email:info@kstarus.Com http://www.Kstarus.Com.
